On 07/09/2012 09:24 AM, Marx wrote:
On 08.07.2012 14:32, Antti Palosaari wrote:
I suspect you stopped szap ?
You cannot use dvbdate or dvbtraffic, nor read data from dvr0 unless
frontend is tuned. Leave szap running backround and try again.
That way it works, and I can save stream. Hovewer it's strange because I
shouldn't have to constatly tune channel to watch it, and on previous
cards it was enough to tune once and then use other commands.
I base my knowledge on
http://www.linuxtv.org/wiki/index.php/Testing_your_DVB_device
There is nothing about constant tuning channel to use it. Am I missing
something?
given wiki-page says:
"
4. After you've tuned a frequency and program
a) You could now start up your simple TV watching application and decode
the stream you have tuned.
For example, while keeping {a,c,s,t}zap running in the first console
shell, open up another console and run
"
Behavior have been always same, at least for the DVB USB.
So you don't have problems at all?
regards
Antti
--
http://palosaari.fi/
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
