On Fri, 2018-05-18 at 15:56 +0200, Jan Luebbe wrote:
> The IPU can only capture RGB565 with two 8-bit cycles in bayer/generic
> mode on the parallel bus, compared to a specific mode on MIPI CSI-2.
> To handle this, we extend imx_media_pixfmt with a cycles per pixel
> field, which is used for generic formats on the parallel bus.
>
> Based on the selected format and bus, we then update the width to
> account for the multiple cycles per pixel.
>
> Signed-off-by: Jan Luebbe <j...@pengutronix.de>
> Signed-off-by: Steve Longerbeam <steve_longerb...@mentor.com>
I only have a small suggestion below, either way:
Reviewed-by: Philipp Zabel <p.za...@pengutronix.de>
> ---
> drivers/staging/media/imx/imx-media-csi.c | 101 +++++++++++++-------
> drivers/staging/media/imx/imx-media-utils.c | 1 +
> drivers/staging/media/imx/imx-media.h | 2 +
> 3 files changed, 71 insertions(+), 33 deletions(-)
>
> diff --git a/drivers/staging/media/imx/imx-media-csi.c
> b/drivers/staging/media/imx/imx-media-csi.c
> index 08b636084286..64e795b0bdae 100644
> --- a/drivers/staging/media/imx/imx-media-csi.c
> +++ b/drivers/staging/media/imx/imx-media-csi.c
[...]
> @@ -389,12 +414,9 @@ static int csi_idmac_setup_channel(struct csi_priv *priv)
> image.phys0 = phys[0];
> image.phys1 = phys[1];
>
> - /*
> - * Check for conditions that require the IPU to handle the
> - * data internally as generic data, aka passthrough mode:
> - * - raw bayer formats
> - * - the CSI is receiving from a 16-bit parallel bus
> - */
> + passthrough = requires_passthrough(&priv->upstream_ep, infmt, incc);
> + passthrough_cycles = 1;
To localize the passthrough cycles handling a bit, I'd remove this line,
...
> +
> switch (image.pix.pixelformat) {
> case V4L2_PIX_FMT_SBGGR8:
> case V4L2_PIX_FMT_SGBRG8:
[...]
> @@ -428,18 +447,25 @@ static int csi_idmac_setup_channel(struct csi_priv
> *priv)
> case V4L2_PIX_FMT_UYVY:
> burst_size = (image.pix.width & 0x1f) ?
> ((image.pix.width & 0xf) ? 8 : 16) : 32;
> - passthrough = is_parallel_16bit_bus(&priv->upstream_ep);
> passthrough_bits = 16;
> break;
> + case V4L2_PIX_FMT_RGB565:
> + if (passthrough) {
> + burst_size = 16;
> + passthrough_bits = 8;
> + passthrough_cycles = incc->cycles;
... remove this line ...
> + break;
> + }
> + /* fallthrough for non-passthrough RGB565 (CSI-2 bus) */
> default:
> burst_size = (image.pix.width & 0xf) ? 8 : 16;
> - passthrough = is_parallel_16bit_bus(&priv->upstream_ep);
> passthrough_bits = 16;
> break;
> }
>
> if (passthrough) {
... and then set
passthrough_cycles = incc->cycles ?: 1;
here.
regards
Philipp
