Add Freescale LS1021A initial defconfig file. The LS1021A SoC is a dual-core Cortex-A7 based processor.
LS1021A has some special configurations against imx_v6_v7_defconfig and multi_v7_defconfig, such as CONFIG_ARM_LPAE, CONFIG_ARM_PSCI... LPAE needs to be supported to access memory beyond the 4GB limit for LS1021A. PSCI needs to be supported for LS1021A too. But CONFIG_ARM_LPAE and CONFIG_ARM_PSCI are disabled in imx_v6_v7_defconfig and multi_v7_defconfig, so a separate LS1021A defconfig is needed. Enable I2C, LPUART, eDMA, WDT, GIANFAR, Sound, DSPI at default. Signed-off-by: Haikun Wang <haikun.w...@freescale.com> Signed-off-by: Alison Wang <alison.w...@freescale.com> --- Changes since v3: - Modify the commit. Changes since v2: - Enable PSCI, as PSCI is enabled in u-boot. Changes since v1: - Enable GIANFAR, Sound and DSPI. arch/arm/configs/ls1021a_defconfig | 160 +++++++++++++++++++++++++++++++++++++ 1 file changed, 160 insertions(+) create mode 100644 arch/arm/configs/ls1021a_defconfig diff --git a/arch/arm/configs/ls1021a_defconfig b/arch/arm/configs/ls1021a_defconfig new file mode 100644 index 0000000..5ec5316 --- /dev/null +++ b/arch/arm/configs/ls1021a_defconfig @@ -0,0 +1,160 @@ +CONFIG_SYSVIPC=y +CONFIG_POSIX_MQUEUE=y +CONFIG_NO_HZ_IDLE=y +CONFIG_HIGH_RES_TIMERS=y +CONFIG_LOG_BUF_SHIFT=16 +CONFIG_BLK_DEV_INITRD=y +CONFIG_CC_OPTIMIZE_FOR_SIZE=y +CONFIG_SYSCTL_SYSCALL=y +CONFIG_KALLSYMS_ALL=y +CONFIG_EMBEDDED=y +CONFIG_PROFILING=y +CONFIG_OPROFILE=y +CONFIG_KPROBES=y +CONFIG_JUMP_LABEL=y +CONFIG_MODULES=y +CONFIG_MODULE_FORCE_LOAD=y +CONFIG_MODULE_UNLOAD=y +CONFIG_BLK_CMDLINE_PARSER=y +CONFIG_ARCH_MXC=y +CONFIG_SOC_LS1021A=y +CONFIG_ARM_LPAE=y +CONFIG_PCI=y +CONFIG_PCI_MSI=y +CONFIG_SMP=y +CONFIG_VMSPLIT_2G=y +CONFIG_ARM_PSCI=y +CONFIG_PREEMPT_VOLUNTARY=y +CONFIG_AEABI=y +CONFIG_HIGHMEM=y +CONFIG_CLEANCACHE=y +CONFIG_FRONTSWAP=y +CONFIG_CMDLINE="console=ttyS0,115200" +CONFIG_VFP=y +CONFIG_NEON=y +CONFIG_KERNEL_MODE_NEON=y +CONFIG_BINFMT_MISC=y +CONFIG_NET=y +CONFIG_PACKET=y +CONFIG_UNIX=y +CONFIG_UNIX_DIAG=y +CONFIG_XFRM_USER=y +CONFIG_NET_KEY=y +CONFIG_INET=y +CONFIG_IP_MULTICAST=y +CONFIG_IP_ADVANCED_ROUTER=y +CONFIG_IP_PNP=y +CONFIG_IP_PNP_DHCP=y +CONFIG_IP_MROUTE=y +CONFIG_INET_AH=y +CONFIG_INET_ESP=y +CONFIG_INET_IPCOMP=y +CONFIG_INET_UDP_DIAG=m +CONFIG_NETFILTER=y +CONFIG_DEVTMPFS=y +CONFIG_DEVTMPFS_MOUNT=y +CONFIG_MTD=y +CONFIG_MTD_CMDLINE_PARTS=y +CONFIG_MTD_BLOCK=y +CONFIG_MTD_CFI=y +CONFIG_MTD_CFI_ADV_OPTIONS=y +CONFIG_MTD_CFI_BE_BYTE_SWAP=y +CONFIG_MTD_CFI_GEOMETRY=y +CONFIG_MTD_CFI_INTELEXT=y +CONFIG_MTD_CFI_AMDSTD=y +CONFIG_MTD_CFI_STAA=y +CONFIG_MTD_PHYSMAP_OF=y +CONFIG_MTD_NAND=y +CONFIG_BLK_DEV_LOOP=y +CONFIG_BLK_DEV_RAM=y +CONFIG_BLK_DEV_RAM_SIZE=256000 +CONFIG_BLK_DEV_SD=y +CONFIG_CHR_DEV_SG=y +CONFIG_ATA=y +CONFIG_NETDEVICES=y +CONFIG_GIANFAR=y +CONFIG_VITESSE_PHY=y +CONFIG_BROADCOM_PHY=y +CONFIG_REALTEK_PHY=y +CONFIG_NATIONAL_PHY=y +CONFIG_MICREL_PHY=y +CONFIG_MDIO_BUS_MUX_MMIOREG=y +CONFIG_INPUT_EVDEV=y +CONFIG_SERIO_SERPORT=m +CONFIG_SERIAL_8250=y +CONFIG_SERIAL_8250_CONSOLE=y +CONFIG_SERIAL_8250_EXTENDED=y +CONFIG_SERIAL_8250_SHARE_IRQ=y +CONFIG_SERIAL_OF_PLATFORM=y +CONFIG_SERIAL_FSL_LPUART=y +CONFIG_SERIAL_FSL_LPUART_CONSOLE=y +CONFIG_HW_RANDOM=y +CONFIG_I2C=y +CONFIG_I2C_CHARDEV=y +CONFIG_I2C_MUX=y +CONFIG_I2C_MUX_PCA954x=y +CONFIG_I2C_IMX=y +CONFIG_SPI=y +CONFIG_SPI_FSL_DSPI=y +CONFIG_GPIO_SYSFS=y +CONFIG_SENSORS_LM90=y +CONFIG_SENSORS_INA2XX=y +CONFIG_WATCHDOG=y +CONFIG_IMX2_WDT=y +CONFIG_REGULATOR=y +CONFIG_REGULATOR_DEBUG=y +CONFIG_REGULATOR_FIXED_VOLTAGE=y +CONFIG_SOUND=y +# CONFIG_SOUND_OSS_CORE_PRECLAIM is not set +CONFIG_SND=y +CONFIG_SND_MIXER_OSS=y +CONFIG_SND_PCM_OSS=y +# CONFIG_SND_ARM is not set +CONFIG_SND_SOC=y +CONFIG_SND_SOC_FSL_SAI=y +CONFIG_SND_SOC_SGTL5000=y +CONFIG_SND_SIMPLE_CARD=y +CONFIG_MMC=y +CONFIG_MMC_SDHCI=y +CONFIG_MMC_SDHCI_PLTFM=y +CONFIG_MMC_SDHCI_OF_ARASAN=y +CONFIG_NEW_LEDS=y +CONFIG_LEDS_CLASS=y +CONFIG_LEDS_TRIGGERS=y +CONFIG_RTC_CLASS=y +CONFIG_RTC_DRV_DS3232=y +CONFIG_DMADEVICES=y +CONFIG_FSL_EDMA=y +CONFIG_CLK_QORIQ=y +CONFIG_MEMORY=y +CONFIG_EXT2_FS=y +CONFIG_EXT2_FS_XATTR=y +CONFIG_EXT3_FS=y +CONFIG_FANOTIFY=y +CONFIG_ISO9660_FS=m +CONFIG_JOLIET=y +CONFIG_ZISOFS=y +CONFIG_UDF_FS=m +CONFIG_MSDOS_FS=y +CONFIG_VFAT_FS=y +CONFIG_NTFS_FS=m +CONFIG_TMPFS=y +CONFIG_TMPFS_POSIX_ACL=y +CONFIG_JFFS2_FS=y +CONFIG_NFS_FS=y +CONFIG_NFS_V4=y +CONFIG_ROOT_NFS=y +CONFIG_NLS_DEFAULT="cp437" +CONFIG_NLS_CODEPAGE_437=y +CONFIG_NLS_ASCII=y +CONFIG_NLS_ISO8859_1=y +CONFIG_NLS_ISO8859_2=y +CONFIG_NLS_ISO8859_15=y +CONFIG_NLS_UTF8=y +CONFIG_DEBUG_SECTION_MISMATCH=y +CONFIG_MAGIC_SYSRQ=y +CONFIG_CRYPTO_LZO=y +CONFIG_CRC_CCITT=m +CONFIG_CRC_T10DIF=y +CONFIG_CRC7=m +CONFIG_LIBCRC32C=m -- 2.1.0.27.g96db324 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
