Hi Anurag,
We're struggling with the same issue, our Cadence QSPI controller *does*
handle four-line command, address, and data, but has to be configured
for it. The setting of quad-io-protocol mode in micron_quad_enable is
really jacking up our code. We have to snoop the command stream and
configure the controller as soon as we see the quad-io-protocol command
go to the Micron chip. Ugly.
I'd like to point out that this flag is also dependent upon the
particular controller in use, not just the Micron chip. In fact, it may
be more of a controller thing than a chip thing.
Maybe this flag should actually be an enum read_mode value, and passed
into spi_nor_scan by the controller?
Thanks,
Graham
On 06/18/2015 09:58 AM, Anurag Kumar Vulisha wrote:
micron flash parts by default operates in extended spi protocol,which accepts
command on single line and can accept address & data on one,two and four lines
depending on the command sent.In set_quad_enable() we are enabling the quad io
protocol for micron flash parts by updating the EVCR register,in this method the
flash expects the command,address and data to be transmitted on all four data
lines which may not be supported on all qspi controllers.So READ_1_1_4 command
does not necessarily go out using those bus widths.
So i have added SPI_QUAD_IO_PROTOCOL flag,which should be checked before
enabling
the quad io protocol.
Signed-off-by: Anurag Kumar Vulisha <anura...@xilinx.com>
---
drivers/mtd/spi-nor/spi-nor.c | 3 +++
1 files changed, 3 insertions(+), 0 deletions(-)
diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
index 14a5d23..a6fa8dc 100644
--- a/drivers/mtd/spi-nor/spi-nor.c
+++ b/drivers/mtd/spi-nor/spi-nor.c
@@ -55,6 +55,7 @@ struct flash_info {
#define SPI_NOR_DUAL_READ 0x20 /* Flash supports Dual Read */
#define SPI_NOR_QUAD_READ 0x40 /* Flash supports Quad Read */
#define USE_FSR 0x80 /* use flag status register */
+#define SPI_QUAD_IO_PROTOCOL 0x100 /* use quad io protocol */
};
#define JEDEC_MFR(info) ((info)->id[0])
@@ -962,6 +963,8 @@ static int set_quad_mode(struct spi_nor *nor, struct
flash_info *info)
}
return status;
case CFI_MFR_ST:
+ if (!(info->flags & SPI_QUAD_IO_PROTOCOL))
+ return 0;
status = micron_quad_enable(nor);
if (status) {
dev_err(nor->dev, "Micron quad-read not enabled\n");
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
Please read the FAQ at http://www.tux.org/lkml/
