Hi, > Hello, > > On Mon, Aug 15, 2005 at 06:10:13PM +0200, [EMAIL PROTECTED] wrote: > > > > Hello, > > > > I try to boot my linux kernel (with 2.4 or 2.6 it's the same problem) on an > > embeded board (EM04N MenMicro) base on a MPC8245 cpu... > > > > When i boot i 've; > > > > > Detected PPCBOOT header > > > Verifying image CRC...ok > > > Uncompressing Multi-File Image ... ok > > > Moving initrd...ok > > > Passing Kernel parameters: root=ramfs console=ttyS0,9600 > > > Starting Linux Kernel. > > > > > and stop here... i must hard reset the board... > > > > Anyone boot a linux kernel on this board ? > > I heard about UART serial port problem with MPC8245 cpu, but i don't find a > > working solution for patching kernel or setting up correctly... > > Although I don't know this board, here are a few questions : > - are you sure that you enabled the correct serial driver and that it is > linked to the zImage and not build as a module ?
I enable and build my kernel with driver (staticly): Multi-IO cards (parallel and serial) (in Device Drivers-> Parallel port support ) This is what my board say (in console mode) about serial address: 0x08 COM1 DUART8245 0xfc004500 0x07a12000 0x00000001 0x01effc70 0x09 COM2 DUART8245 0xfc004600 0x07a12000 0x00000001 0x01e107d0 > - are you sure that you enabled "console on serial port" in the config ? Yes, i enable " Support for console on virtual terminal" but i enable "Non-standard serial port support" option too... So i recompile without the last one... and i recompile "with Serial drivers --->" "[*] Console on 8250/16550 and compatible serial port" perhaps it's that... And i came back to you. But, perhaps i've allready tested... i ll check.. it's not a default option ? > - how can you be certain that the serial will appear on ttyS0 and not ttyS1 > or another one (the kernel might detect another serial port which it > assigns ttyS0) I pass parameter directly to the kernel; Another option i set : Default bootloader kernel arguments x x x x(console=ttyS0,9600 console=tty0 Thanks Yann. > - is it possible that you have trouble with the endianness of the image ? > example: little endian image loaded on big endian CPU ? My image seems to be ok... > > Regards, > Willy > > > Anyone can help me ? > > > > I use : > > ELDK kit cross compilation for PPC8245 > > uBoot > > and official last kernel source... > > > > Thanks > > - > > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in > > the body of a message to [EMAIL PROTECTED] > > More majordomo info at http://vger.kernel.org/majordomo-info.html > > Please read the FAQ at http://www.tux.org/lkml/ > - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
