On Sun, 14 Aug 2005 09:29, Dave Jones wrote:
> I've noticed this week whilst trying to encode a bunch
> of audio CDs to oggs that my boxes running the latest
> kernels are having serious issues, whereas 2.6.12 seems
> to cope just fine.
>
> The symptoms vary. On some of my machines just inserting
> an audio CD makes the box instantly lock up.
> If I boot with the same CD in the drive, sound-juicer
> can read it just fine. When I get to the next CD, I have
> to reboot again, or it locks up.
>
> On another box, it gets stuck in a loop where it
> just prints out..
>
> hdc: irq timeout: status=0xd0 { Busy } (This line sometimes has
> status=0xc0) ide: failed opcode was: unknown
>
> The net result is that I've not got a single box that
> will read audio CDs without doing something bad, and I've
> tried it on several quite diverse systems.
>
>
> I'll try and narrow down over the next few days when this
> started happening, but IDE / CD folks may have some better
> ideas about which changes were suspicious.
Ok I just started noticing unusual things on my IDE DVD-RW as well, presumably
related, on 2.6.13-rc6. Putting in a cd and trying to read it will cause huge
delays and then error out with:
ide-cd: cmd 0x28 timed out
hdc: DMA timeout retry
hdc: timeout waiting for DMA
hdc: status timeout: status=0xd0 { Busy }
ide: failed opcode was: unknown
hdc: drive not ready for command
hdc: ATAPI reset complete
then it will read fine. If I start another read it goes through the same
cycle. Forcing dma *off* with hdparm fixes the problem and all subsequent
accesses don't have this pause, however this was never an issue on previous
kernels with dma working fine.
relevant lspci:
00:1d.0 USB Controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) USB
UHCI Controller #1 (rev 02)
00:1d.1 USB Controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) USB
UHCI Controller #2 (rev 02)
00:1d.2 USB Controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) USB
UHCI Controller #3 (rev 02)
00:1d.7 USB Controller: Intel Corp. 82801DB/DBM (ICH4/ICH4-M) USB 2.0 EHCI
Controller (rev 02)
hdparm info of hdc:
/dev/hdc:
ATAPI CD-ROM, with removable media
Model Number: LITE-ON DVDRW SOHW-1653S
Serial Number:
Firmware Revision: CS02
Standards:
Used: ATAPI for CD-ROMs, SFF-8020i, r2.5
Supported: CD-ROM ATAPI-2
Configuration:
DRQ response: 50us.
Packet size: 12 bytes
Capabilities:
LBA, IORDY(cannot be disabled)
DMA: mdma0 mdma1 mdma2 udma0 udma1 *udma2 udma3 udma4
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=227ns IORDY flow control=120ns
relevant config=y info:
CONFIG_IDE=y
CONFIG_BLK_DEV_IDE=y
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_IDEDISK_MULTI_MODE=y
CONFIG_BLK_DEV_IDECD=y
CONFIG_BLK_DEV_IDEPCI=y
CONFIG_IDEPCI_SHARE_IRQ=y
CONFIG_BLK_DEV_IDEDMA_PCI=y
CONFIG_IDEDMA_PCI_AUTO=y
CONFIG_BLK_DEV_PIIX=y
CONFIG_BLK_DEV_IDEDMA=y
CONFIG_IDEDMA_IVB=y
CONFIG_IDEDMA_AUTO=y
Cheers,
Con
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
