On 05/20/15 20:57, Bintian wrote:
>
>>
>>>
>>> +
>>> +static void __init hi6220_clk_sys_init(struct device_node *np)
>>> +{
>>> + struct hisi_clock_data *clk_data;
>>> +
>>> + clk_data = hisi_clk_init(np, HI6220_SYS_NR_CLKS);
>>> + if (!clk_data)
>>> + return;
>>> +
>>> + hisi_clk_register_gate_sep(hi6220_separated_gate_clks_sys,
>>> + ARRAY_SIZE(hi6220_separated_gate_clks_sys), clk_data);
>>> +
>>> + hisi_clk_register_mux(hi6220_mux_clks_sys,
>>> + ARRAY_SIZE(hi6220_mux_clks_sys), clk_data);
>>> +
>>> + hi6220_clk_register_divider(hi6220_div_clks_sys,
>>> + ARRAY_SIZE(hi6220_div_clks_sys), clk_data);
>>> +
>>> + if (!clk_data_ao)
>>> + return;
>>> +
>>> + /* enable high speed clock on UART1 mux */
>>> + clk_set_parent(clk_data->clk_data.clks[HI6220_UART1_SRC],
>>> + clk_data_ao->clk_data.clks[HI6220_150M]);
>>
>> Sorry I missed this one earlier. Can we do this clk_set_parent() through
>> assigned-parents instead?
> Uart1 has two clock parents in hi6220, and use "clk_tcxo" by default,
> we use uart1 to connect BT in HiKey, and switch to "clk_150m" for high
> speed mode of BT, but pl011 has no code to set clock rate or set clock
> parents operation, so it's a easy way to do that here.
Is pl011 the uart device? Does it have a node in DT somewhere? If it
does, then we could put the assigned-parents properties in that node so
that when the pl011 probes the uart1 clock has its parent set to
clk_150m. See the "Assigned clock parents and rates" section of
Documentation/devicetree/bindings/clock/clock-bindings.txt.
--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
