If we power up vqmmc in MMC_POWER_ON then we end up turning it on before mmc_power_up() sets the signal voltage. That's not so great since we might be powering it up at the wrong voltage.
Note that this is how Yuvaraj originally coded things up in <https://patchwork.kernel.org/patch/4401231/> but he changed it on my suggestion. Apparently I was wrong. Reported-by: Alexandru M Stan <ams...@chromium.org> Signed-off-by: Doug Anderson <diand...@chromium.org> --- drivers/mmc/host/dw_mmc.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c index 2e8abc8..4d2e3c2 100644 --- a/drivers/mmc/host/dw_mmc.c +++ b/drivers/mmc/host/dw_mmc.c @@ -1119,6 +1119,12 @@ static void dw_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios) return; } } + set_bit(DW_MMC_CARD_NEED_INIT, &slot->flags); + regs = mci_readl(slot->host, PWREN); + regs |= (1 << slot->id); + mci_writel(slot->host, PWREN, regs); + break; + case MMC_POWER_ON: if (!IS_ERR(mmc->supply.vqmmc) && !slot->host->vqmmc_enabled) { ret = regulator_enable(mmc->supply.vqmmc); if (ret < 0) @@ -1127,10 +1133,6 @@ static void dw_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios) else slot->host->vqmmc_enabled = true; } - set_bit(DW_MMC_CARD_NEED_INIT, &slot->flags); - regs = mci_readl(slot->host, PWREN); - regs |= (1 << slot->id); - mci_writel(slot->host, PWREN, regs); break; case MMC_POWER_OFF: if (!IS_ERR(mmc->supply.vmmc)) -- 2.2.0.rc0.207.ga3a616c -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
