Hello,
Miquel van Smoorenburg wrote:
I have a supermicro dual xeon em64t system, X6DH8-XG2 motherboard, 4 GB RAM, with an Adaptec zero raid 2010S i2o controller. In 32 bits mode it runs fine, both with the dpt_i2o driver and the generic i2o_block driver using kernel 2.6.11.6. In 64 bits mode however the dpt_i2o driver isn't supported, so you have to use the generic i2o layer. But that doesn't work either - sometimes when booting the partition table is detected, sometimes it isn't. If it isn't, then fdisk /dev/i2o/hda works but shows an empty disk (while there definitely are partitions present) In both cases doing a dd if=/dev/i2o/hda of=/dev/null crashes the system. According to http://i2o.shadowconnect.com/ , it should work. I've upgraded the BIOS and firmware of the mobo and controller to the latest versions - doesn't help. Can someone suggest what to try next ?
Could you try out the 2.6.9 kernel, because i know that this one is working?
Also could you send me a complete output of dmesg?
Thank you very much.
Best regards,
Markus Lidel ------------------------------------------ Markus Lidel (Senior IT Consultant)
Shadow Connect GmbH Carl-Reisch-Weg 12 D-86381 Krumbach Germany
Phone: +49 82 82/99 51-0 Fax: +49 82 82/99 51-11
E-Mail: [EMAIL PROTECTED] URL: http://www.shadowconnect.com - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
