Hello Hao Liang
On 9/30/2014 7:55 AM, hliang1...@gmail.com wrote:
From: Hao Liang <hliang1...@gmail.com>
This is the fix for a power management issue caused by suspend and resume
function in stmmac_main.c.
After enable CONFIG_DEBUG_ATOMIC_SLEEP which enable sleep-inside atomic section
checking, power
managemet can not work normally. Board couldn't wakeup successfully after
suspend. Command
"echo mem > /sys/power/state" suspend the board.
In suspend and resume function of stmmac driver, there are some sleep-inside
function in atomic section
created by spin lock. These functions will causes system warnings and wakeup
issue when enable
CONFIG_DEBUG_ATOMIC_SLEEP.
This bug was fixed by:
* replace some sleep function with non-sleep function
clk_disable_unprepare -> clk_disable ...
* decrease the atomic area created by spin lock function. The original atomic
area in resume function is
too large.
I had done something in this patch:
[PATCH (net.git)] stmmac: fix and review whole driver locking
Indeed I was not able to review it after some advice but I will do it!
So we can review your patch and then I will re-base my work on top of
yours.
I just wonder if the spinlock can be safely removed instead of
surrounding just the code to clear the descriptors that should
not be claimed by others. Maybe the only part shared is the
stmmac_hw_setup that can be invoked by open method.
peppe
Signed-off-by: Hao Liang <hliang1...@gmail.com>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 13 +++++++------
1 file changed, 7 insertions(+), 6 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 6e6ee22..2effbfe 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -2924,9 +2924,8 @@ int stmmac_suspend(struct net_device *ndev)
if (priv->phydev)
phy_stop(priv->phydev);
- spin_lock_irqsave(&priv->lock, flags);
-
netif_device_detach(ndev);
+
netif_stop_queue(ndev);
napi_disable(&priv->napi);
@@ -2935,6 +2934,8 @@ int stmmac_suspend(struct net_device *ndev)
priv->hw->dma->stop_tx(priv->ioaddr);
priv->hw->dma->stop_rx(priv->ioaddr);
+ spin_lock_irqsave(&priv->lock, flags);
+
stmmac_clear_descriptors(priv);
/* Enable Power down mode by programming the PMT regs */
@@ -2945,7 +2946,7 @@ int stmmac_suspend(struct net_device *ndev)
stmmac_set_mac(priv->ioaddr, false);
pinctrl_pm_select_sleep_state(priv->device);
/* Disable clock in case of PWM is off */
- clk_disable_unprepare(priv->stmmac_clk);
+ clk_disable(priv->stmmac_clk);
}
spin_unlock_irqrestore(&priv->lock, flags);
@@ -2977,12 +2978,14 @@ int stmmac_resume(struct net_device *ndev)
} else {
pinctrl_pm_select_default_state(priv->device);
/* enable the clk prevously disabled */
- clk_prepare_enable(priv->stmmac_clk);
+ clk_enable(priv->stmmac_clk);
/* reset the phy so that it's ready */
if (priv->mii)
stmmac_mdio_reset(priv->mii);
}
+ spin_unlock_irqrestore(&priv->lock, flags);
+
netif_device_attach(ndev);
stmmac_hw_setup(ndev);
@@ -2991,8 +2994,6 @@ int stmmac_resume(struct net_device *ndev)
netif_start_queue(ndev);
- spin_unlock_irqrestore(&priv->lock, flags);
-
if (priv->phydev)
phy_start(priv->phydev);
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
