Hi, On Wednesday 03 September 2014 09:07 PM, Gabriel FERNANDEZ wrote: > The MiPHY28lp is a Generic PHY which can serve various SATA or PCIe > or USB3 devices. > > Signed-off-by: alexandre torgue <alexandre.tor...@st.com> > Signed-off-by: Giuseppe Cavallaro <peppe.cavall...@st.com> > Signed-off-by: Gabriel Fernandez <gabriel.fernan...@linaro.org> > --- > .../devicetree/bindings/phy/phy-miphy28lp.txt | 126 > +++++++++++++++++++++ > 1 file changed, 126 insertions(+) > create mode 100644 Documentation/devicetree/bindings/phy/phy-miphy28lp.txt > > diff --git a/Documentation/devicetree/bindings/phy/phy-miphy28lp.txt > b/Documentation/devicetree/bindings/phy/phy-miphy28lp.txt > new file mode 100644 > index 0000000..5e307af > --- /dev/null > +++ b/Documentation/devicetree/bindings/phy/phy-miphy28lp.txt > @@ -0,0 +1,126 @@ > +STMicroelectronics STi MIPHY28LP PHY binding > +============================================ > + > +This binding describes a miphy device that is used to control PHY hardware > +for SATA, PCIe or USB3. > + > +Required properties (controller (parent) node): > +- compatible : Should be "st,miphy28lp-phy" > +- st,syscfg : Should be a phandle of the system configuration register group > + which contain the SATA, PCIe or USB3 mode setting bits > + > +Required nodes : A sub-node is required for each channel the > controller > + provides. Address range information including the usual > + 'reg' and 'reg-names' properties are used inside these > + nodes to describe the controller's topology. These nodes > + are translated by the driver's .xlate() function. > + > +Required properties (port (child) node): > +- #phy-cells : Should be 1 (See second example) > + Cell after port phandle is device type from: > + - MIPHY_TYPE_SATA > + - MIPHY_TYPE_PCI > + - MIPHY_TYPE_USB3 > +- reg : Address and length of the register set for the device > +- reg-names : The names of the register addresses corresponding to the > registers > + filled in "reg". Is can also contain the offset of the system > configuration
%s/Is/It Thanks Kishon -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
