From: Chew, Chiau Ee <chiau.ee.c...@intel.com>
It was observed that after module removal followed by insertion,
the SW mode chipselect is not properly set. Thus causing transfer
failure due to incorrect CS toggling.
Signed-off-by: Chew, Chiau Ee <chiau.ee.c...@intel.com>
---
drivers/spi/spi-pxa2xx.c | 8 ++++++--
1 files changed, 6 insertions(+), 2 deletions(-)
diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c
index a98df7e..fe79210 100644
--- a/drivers/spi/spi-pxa2xx.c
+++ b/drivers/spi/spi-pxa2xx.c
@@ -118,6 +118,7 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
*/
orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
+ /* Test SPI_CS_CONTROL_SW_MODE bit enabling */
value = orig | SPI_CS_CONTROL_SW_MODE;
writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
@@ -126,10 +127,13 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
goto detection_done;
}
- value &= ~SPI_CS_CONTROL_SW_MODE;
+ orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
+
+ /* Test SPI_CS_CONTROL_SW_MODE bit disabling */
+ value = orig & ~SPI_CS_CONTROL_SW_MODE;
writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
- if (value != orig) {
+ if (value != (orig & ~SPI_CS_CONTROL_SW_MODE)) {
offset = 0x800;
goto detection_done;
}
--
1.7.4.4
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
