On Fri, Mar 14, 2014 at 06:18:27PM -0500, Scott Wood wrote: > On Wed, 2014-03-12 at 18:40 +0800, Chenhui Zhao wrote: > > On Tue, Mar 11, 2014 at 08:10:24PM -0500, Scott Wood wrote: > > > On Fri, 2014-03-07 at 12:58 +0800, Chenhui Zhao wrote: > > > > From: Zhao Chenhui <chenhui.z...@freescale.com> > > > > > > > > T1040 supports deep sleep feature, which can switch off most parts of > > > > the SoC when it is in deep sleep mode. This way, it becomes more > > > > energy-efficient. > > > > > > > > The DDR controller will also be powered off in deep sleep. Therefore, > > > > the last stage (the latter part of fsl_dp_enter_low) will run without > > > > DDR > > > > access. This piece of code and related TLBs will be prefetched. > > > > > > > > Due to the different initialization code between 32-bit and 64-bit, they > > > > have seperate resume entry and precedure. > > > > > > > > The feature supports 32-bit and 64-bit kernel mode. > > > > > > > > Signed-off-by: Zhao Chenhui <chenhui.z...@freescale.com> > > > > --- > > > > arch/powerpc/include/asm/booke_save_regs.h | 3 + > > > > arch/powerpc/kernel/cpu_setup_fsl_booke.S | 17 ++ > > > > arch/powerpc/kernel/head_fsl_booke.S | 30 +++ > > > > arch/powerpc/platforms/85xx/Makefile | 2 +- > > > > arch/powerpc/platforms/85xx/deepsleep.c | 201 +++++++++++++++++++ > > > > arch/powerpc/platforms/85xx/qoriq_pm.c | 38 ++++ > > > > arch/powerpc/platforms/85xx/sleep.S | 295 > > > > ++++++++++++++++++++++++++++ > > > > arch/powerpc/sysdev/fsl_soc.h | 7 + > > > > 8 files changed, 592 insertions(+), 1 deletions(-) > > > > create mode 100644 arch/powerpc/platforms/85xx/deepsleep.c > > > > create mode 100644 arch/powerpc/platforms/85xx/sleep.S > > > > > > > > diff --git a/arch/powerpc/include/asm/booke_save_regs.h > > > > b/arch/powerpc/include/asm/booke_save_regs.h > > > > index 87c357a..37c1f6c 100644 > > > > --- a/arch/powerpc/include/asm/booke_save_regs.h > > > > +++ b/arch/powerpc/include/asm/booke_save_regs.h > > > > @@ -88,6 +88,9 @@ > > > > #define HIBERNATION_FLAG 1 > > > > #define DEEPSLEEP_FLAG 2 > > > > > > > > +#define CPLD_FLAG 1 > > > > +#define FPGA_FLAG 2 > > > > > > What is this? > > > > We have two kind of boards, QDS and RDB. > > They have different register map. Use the flag to indicate the current > > board is using which kind > > of register map. > > CPLD versus FPGA is not a meaningful difference. We don't care what > technology is used to implement programmable logic -- we care what > programming interface is exposed. Customers will have their own boards > that will likely not imitate either of these programming interfaces, but > what they do have will still probably be implemented in a CPLD or FPGA. > Likewise, Freescale may have future reference boards whose CPLD/FPGA is > not compatible.
Will use a better name. > > So use better naming, and structure the code so it's easy to plug in > implementations for new or custom boards. > > > > > diff --git a/arch/powerpc/kernel/head_fsl_booke.S > > > > b/arch/powerpc/kernel/head_fsl_booke.S > > > > index 20204fe..3285752 100644 > > > > --- a/arch/powerpc/kernel/head_fsl_booke.S > > > > +++ b/arch/powerpc/kernel/head_fsl_booke.S > > > > @@ -162,6 +162,19 @@ _ENTRY(__early_start) > > > > #include "fsl_booke_entry_mapping.S" > > > > #undef ENTRY_MAPPING_BOOT_SETUP > > > > > > > > +#if defined(CONFIG_SUSPEND) && defined(CONFIG_FSL_CORENET_RCPM) > > > > + /* if deep_sleep_flag != 0, jump to the deep sleep resume entry > > > > */ > > > > + LOAD_REG_ADDR(r4, deep_sleep_flag) > > > > + lwz r3, 0(r4) > > > > + cmpwi r3, 0 > > > > + beq 11f > > > > + /* clear deep_sleep_flag */ > > > > + li r3, 0 > > > > + stw r3, 0(r4) > > > > + b fsl_deepsleep_resume > > > > +11: > > > > +#endif > > > > > > Why do you come in via the normal kernel entry, versus specifying a > > > direct entry point for deep sleep resume? How does U-Boot even know > > > what the normal entry is when resuming? > > > > I wish to return to a specified point (like 64-bit mode), but the code in > > fsl_booke_entry_mapping.S only can run in the first page. Because it > > only setups a temp mapping of 4KB. > > Why do you need the entry mapping on 32-bit but not 64-bit? fsl_booke_entry_mapping.S is for 32-bit. 64-bit calls initial_tlb_book3e() in exceptions-64e.S. > > > > > > +#if defined(CONFIG_SUSPEND) && defined(CONFIG_FSL_CORENET_RCPM) > > > > +_ENTRY(__entry_deep_sleep) > > > > +/* > > > > + * Bootloader will jump to here when resuming from deep sleep. > > > > + * After executing the init code in fsl_booke_entry_mapping.S, > > > > + * will jump to the real resume entry. > > > > + */ > > > > + li r8, 1 > > > > + bl 12f > > > > +12: mflr r9 > > > > + addi r9, r9, (deep_sleep_flag - 12b) > > > > + stw r8, 0(r9) > > > > + b __early_start > > > > +deep_sleep_flag: > > > > + .long 0 > > > > +#endif > > > > > > It's a bit ambiguous to say "entry_deep_sleep" when it's resuming rather > > > than entering... > > > > How about __fsl_entry_resume? > > fsl_booke_deep_sleep_resume > > > > > +#define FSLDELAY(count) \ > > > > + li r3, (count)@l; \ > > > > + slwi r3, r3, 10; \ > > > > + mtctr r3; \ > > > > +101: nop; \ > > > > + bdnz 101b; > > > > > > You don't need a namespace prefix on local macros in a non-header file. > > > > > > Is the timebase stopped where you're calling this from? > > > > No. My purpose is to avoid jump in the last stage of entering deep sleep. > > Jump may cause problem at that time. > > "bdnz" is a jump. > > What problems do you think a jump will cause? I mean a far jump which can jump to an address which has not been prefetched in advance. I wish the code is executed in a restricted environment (predictable code and address). > > > > You also probably want to do a "sync, readback, data dependency, isync" > > > sequence to make sure that the store has hit CCSR before you begin your > > > delay (or is a delay required at all if you do that?). > > > > Yes. It is safer with a sync sequence. > > > > The DDR controller need some time to signal the external DDR modules to > > enter self refresh mode. > > Is it documented how much time it requires? > > -Scott No. -Chenhui -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
