Hello,
On Sun, 6 Feb 2005, OGAWA Hirofumi wrote:
Marco Rogantini <[EMAIL PROTECTED]> writes:
sort kernel: NETDEV WATCHDOG: eth1: transmit timed out sort kernel: eth1: Transmit timeout, status 0d 0000 c07f media 00.
This state seems the hardware problem. Probably TX pending was not processed, so any pending interrupts is nothing.
What CardBus bridge are you using? If TI12xx bridge, can you try the attached patch? (Try "disable_clkrun" module option with yenta_socket.ko)
Many thanks for your help,
I'm using a TI-PCI4510 on a Dell Inspiron 8500. Kernel is linux-2.6.11-rc3 and your patch is already included there.
I tried to load the module with 'disable_clkrun' option but nothing has changed... :-(
dmesg extract:
Linux Kernel Card Services options: [pci] [cardbus] [pm] PCI: Enabling device 0000:02:01.0 (0000 -> 0002) ACPI: PCI interrupt 0000:02:01.0[A] -> GSI 11 (level, low) -> IRQ 11 Yenta: CardBus bridge found at 0000:02:01.0 [1028:013e] Yenta: ISA IRQ mask 0x04d8, PCI irq 11 Socket status: 30000020 8139too Fast Ethernet driver 0.9.27 PCI: Enabling device 0000:03:00.0 (0000 -> 0003) ACPI: PCI interrupt 0000:03:00.0[A] -> GSI 11 (level, low) -> IRQ 11 PCI: Setting latency timer of device 0000:03:00.0 to 64 eth1: RealTek RTL8139 at 0xe0824000, 00:30:4f:35:da:7f, IRQ 11 eth1: Identified 8139 chip type 'RTL-8139C'
lspci | grep -i cardbus:
0000:02:01.0 CardBus bridge: Texas Instruments PCI4510 PC card Cardbus Controller (rev 02)
It is perhaps that IRQ11 is shared with a lot of other devices?
cat /proc/interrupts:
CPU0
0: 872193 XT-PIC timer
1: 652 XT-PIC i8042
2: 0 XT-PIC cascade
8: 4 XT-PIC rtc
9: 2 XT-PIC acpi
11: 32031 XT-PIC ehci_hcd, uhci_hcd, uhci_hcd, uhci_hcd, yenta, eth0, eth1
12: 106 XT-PIC i8042
14: 4432 XT-PIC ide0
15: 12 XT-PIC ide1
NMI: 0
LOC: 872045
ERR: 0
MIS: 0
In any case, many thanks for your contributions!
-marco - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
