Add ethernet phy node in at91rm9200ek.dts.
The reg register is not specified, as it may differ depending on the init
process of the board:
ADDR0/1 phy pins are connected to PA13/14 rm9200 pins. Which means the phy
will take its address from these pins during the reset process.
The macb driver will launch a full scan on the mdio bus to discover the phy
address.
Signed-off-by: Boris BREZILLON <b.brezil...@overkiz.com>
---
arch/arm/boot/dts/at91rm9200ek.dts | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/arch/arm/boot/dts/at91rm9200ek.dts
b/arch/arm/boot/dts/at91rm9200ek.dts
index d2d72c3..37b0880 100644
--- a/arch/arm/boot/dts/at91rm9200ek.dts
+++ b/arch/arm/boot/dts/at91rm9200ek.dts
@@ -47,6 +47,11 @@
macb0: ethernet@fffbc000 {
phy-mode = "rmii";
status = "okay";
+
+ phy0: ethernet-phy {
+ interrupt-parent = <&pioC>;
+ interrupts = <4 IRQ_TYPE_EDGE_FALLING>;
+ };
};
usb1: gadget@fffb0000 {
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
