On Thursday, July 25, 2013 10:05 PM, Maxime Ripard wrote:
>
> The IM pins of the HX8357 controller are used to define the interface
> used to feed pixel stream to the LCD panel.
>
> Most of the time, these pins are directly routed to either the ground or
> the VCC to set their values.
>
> Remove the need to assign GPIOs to these pins when we are in such a case.
>
> Signed-off-by: Maxime Ripard <maxime.rip...@free-electrons.com>
> ---
> drivers/video/backlight/hx8357.c | 53
> +++++++++++++++++++++++-----------------
> 1 file changed, 31 insertions(+), 22 deletions(-)
>
[.....]
> + if (of_find_property(spi->dev.of_node, "im-gpios", NULL)) {
> + lcd->use_im_pins = 1;
> +
> + for (i = 0; i < HX8357_NUM_IM_PINS; i++) {
> + lcd->im_pins[i] = of_get_named_gpio(spi->dev.of_node,
> + "im-gpios", i);
> + if (lcd->im_pins[i] == -EPROBE_DEFER) {
> + dev_info(&spi->dev, "GPIO requested is not here
> yet, deferring the
> probe\n");
> + return -EPROBE_DEFER;
> + }
> + if (!gpio_is_valid(lcd->im_pins[i])) {
> + dev_err(&spi->dev, "Missing dt property:
> im-gpios\n");
> + return -EINVAL;
> + }
> +
> + ret = devm_gpio_request_one(&spi->dev, lcd->im_pins[i],
> + GPIOF_OUT_INIT_LOW,
> + "im_pins");
> + if (ret) {
> + dev_err(&spi->dev, "failed to request gpio %d:
> %d\n",
> + lcd->im_pins[i], ret);
> + return -EINVAL;
> + }
> }
> -
> - ret = devm_gpio_request_one(&spi->dev, lcd->im_pins[i],
> - GPIOF_OUT_INIT_LOW, "im_pins");
> - if (ret) {
> - dev_err(&spi->dev, "failed to request gpio %d: %d\n",
> - lcd->im_pins[i], ret);
> - return -EINVAL;
> - }
> - }
> + } else
> + lcd->use_im_pins = 0;
According to the 'Documentation/CodingStyle', braces are necessary as below.
} else {
lcd->use_im_pins = 0;
}
Others look good.
Acked-by: Jingoo Han <jg1....@samsung.com>
Best regards,
Jingoo Han
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
