From: Patrice Chotard <[email protected]> Replace hardcoded value by corresponding #define's.
Signed-off-by: Patrice Chotard <[email protected]> --- drivers/pinctrl/pinctrl-abx500.c | 21 +++++++++++++++++---- 1 file changed, 17 insertions(+), 4 deletions(-) diff --git a/drivers/pinctrl/pinctrl-abx500.c b/drivers/pinctrl/pinctrl-abx500.c index caa7ab6..7696bfd 100644 --- a/drivers/pinctrl/pinctrl-abx500.c +++ b/drivers/pinctrl/pinctrl-abx500.c @@ -96,6 +96,9 @@ #define AB8540_GPIOX_VBAT_START 51 #define AB8540_GPIOX_VBAT_END 54 +#define ABX500_GPIO_INPUT 0 +#define ABX500_GPIO_OUTPUT 1 + struct abx500_pinctrl { struct device *dev; struct pinctrl_dev *pctldev; @@ -264,12 +267,18 @@ static int abx500_gpio_direction_output(struct gpio_chip *chip, int ret; /* set direction as output */ - ret = abx500_gpio_set_bits(chip, AB8500_GPIO_DIR1_REG, offset, 1); + ret = abx500_gpio_set_bits(chip, + AB8500_GPIO_DIR1_REG, + offset, + ABX500_GPIO_OUTPUT); if (ret < 0) return ret; /* disable pull down */ - ret = abx500_gpio_set_bits(chip, AB8500_GPIO_PUD1_REG, offset, 1); + ret = abx500_gpio_set_bits(chip, + AB8500_GPIO_PUD1_REG, + offset, + ABX500_GPIO_PULL_NONE); if (ret < 0) return ret; @@ -290,7 +299,10 @@ static int abx500_gpio_direction_output(struct gpio_chip *chip, static int abx500_gpio_direction_input(struct gpio_chip *chip, unsigned offset) { /* set the register as input */ - return abx500_gpio_set_bits(chip, AB8500_GPIO_DIR1_REG, offset, 0); + return abx500_gpio_set_bits(chip, + AB8500_GPIO_DIR1_REG, + offset, + ABX500_GPIO_INPUT); } static int abx500_gpio_to_irq(struct gpio_chip *chip, unsigned offset) @@ -1018,7 +1030,8 @@ static int abx500_pin_config_set(struct pinctrl_dev *pctldev, else /* Chip only supports pull down */ ret = abx500_gpio_set_bits(chip, AB8500_GPIO_PUD1_REG, - offset, argument ? 0 : 1); + offset, + argument ? ABX500_GPIO_PULL_DOWN : ABX500_GPIO_PULL_NONE); break; case PIN_CONFIG_BIAS_PULL_UP: -- 1.7.10 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
