Hello,
I was testing the framebuffer on an i.MX28 based platform and found out that the lcdif
clock is actually bypassed to use the ref_xtal of 24MHz, which makes the
clk_set_rate() call in the driver useless (as well as the pixclock settings in
fb_videomode variables in mach-mxs.c):
static void mxsfb_enable_controller(struct fb_info *fb_info)
{
struct mxsfb_info *host = to_imxfb_host(fb_info);
u32 reg;
dev_dbg(&host->pdev->dev, "%s\n", __func__);
clk_prepare_enable(host->clk);
clk_set_rate(host->clk, PICOS2KHZ(fb_info->var.pixclock) * 1000U);
This can easily be checked by probing the pixel clock signal.
Is this known or did it go unnoticed because the supported displays work ok with the
bypassed 24MHz frequency?
If using a pixel clock below 24MHz, the divisor will round to 2 thus generating a
12MHz signal.
On the MX28EVK board with the Seiko 4.3" LCD, I do not see the penguin or any image in
v3.8 or v3.9 though the framebuffer device is present and correctly loaded and
backlight on.
This LCD works in kernel v2.6.35 with the same 24MHz frequency.
@Fabio, does this LCD work out of the box on v3.9? Am I missing something?
Thank you.
--
Héctor Palacios
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
