Does anyone has any suggestions on fixing 'USB HC TakeOver failed!'
problem. thanks.
syslog
------
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
PCI: Setting latency timer of device 01:04.0 to 64
usb-ohci.c: USB OHCI at membase 0xc8914000, IRQ 8
usb-ohci.c: usb-01:04.0, CMD Technology Inc USB0670
>>>> usb-ohci.c: USB HC TakeOver failed!
usb.c: USB bus -1 deregistered
usb.c: deregistering driver usbdevfs
usb.c: deregistering driver hub
lspci -vv -s 01:04
------------------
01:04.0 USB Controller: CMD Technology Inc USB0670 (rev 06) (prog-if 10 [OHCI])
Subsystem: CMD Technology Inc USB0670
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 0 (500ns min, 1000ns max)
Interrupt: pin A routed to IRQ 8
Region 0: Memory at 10000000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0-,D1+,D2+,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
lspci
--------
00:00.0 Host bridge: VLSI Technology Inc 82C592-FC1 (rev 01)
00:01.0 ISA bridge: VLSI Technology Inc 82C593-FC1 (rev 01)
00:0d.0 IDE interface: CMD Technology Inc PCI0640 (rev 02)
00:10.0 PCI bridge: Digital Equipment Corporation DECchip 21152 (rev 03)
00:11.0 VGA compatible controller: S3 Inc. 86c764/765 [Trio32/64/64V+]
00:12.0 SCSI storage controller: BusLogic BT-946C (BA80C30) [MultiMaster 10]
01:04.0 USB Controller: CMD Technology Inc USB0670 (rev 06)
01:05.0 FireWire (IEEE 1394): Texas Instruments: Unknown device 8020
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
