On Tue, 20 Mar 2001 16:32:48 -0500 (EST)
Mark Hahn <[EMAIL PROTECTED]> wrote:
>
> .... hdparm -t cannot be effected by the filesystem
> that lives in the partition, since hdparm is doing reads that don't
> go through the filesystem. hmm, I wonder if that's it: if you mount
> the FS that's in hda1, it might change the block driver configuration
> (changing the blocksize, for instance). that would effect hdparm,
> even though its reads don't go through the FS.
>
> prediction: if you comment out the hda1 line in fstab, and reboot,
> so that vfat never gets mounted on that partition, I predict that
> hdparm will show >30.19 MB/s on it.
>
Hi Mark,
I commented out the line. Mtab now reported:
/dev/hda7 / ext2 rw 0 0
proc /proc proc rw 0 0
/dev/hda5 /boot ext2 rw 0 0
devpts /dev/pts devpts rw 0 0
The result of hdparm -tT /dev/hda was, however, exactly the same as before (ie circa
15 MB/sec. The results for /dev/hda7 remain at about 30 MB/sec.
Further, even though the relevant line was commented out of fstab, I could still
perform hdparm -tT /dev/hda1 (giving the usual 15 MB/sec). I suppose that this is
because fdisk still showed :
Disk /dev/hda: 255 heads, 63 sectors, 3737 cylinders
Units = cylinders of 16065 * 512 bytes
Device Boot Start End Blocks Id System
/dev/hda1 * 1 932 7486258+ b Win95 FAT32
/dev/hda2 933 3737 22531162+ 5 Extended
/dev/hda5 933 935 24066 83 Linux
/dev/hda6 936 952 136521 82 Linux swap
/dev/hda7 953 3737 22370481 83 Linux
On the other hand, am I correct in interpreting the bonnie output for the block read
(included in my earlier post), of 20937 KB/sec as reasonably healthy for my DTLA (ie
consistent with hdparm's 30 MB/sec), when performing more realistic tasks on the linux
filesystem ?
Regards,
Geoff
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
