On Fri, 9 Mar 2001, davide.rossetti wrote:
> Hi folks,
> after a long time, I tried to upgrade the kernel I use to boot some
> diskless PIII Katmai, C-PCI hosts (attached lspci -vv) with DEC ethernet
> chips.
sorry. forgot to attach the pci dev dump. regards
--
+------------------------------------------------------------------+
|Rossetti Davide INFN - Sezione Roma I - gruppo V, prog. APEmille|
| web : http://apegate.roma1.infn.it/~rossetti |
| """"" E-mail : [EMAIL PROTECTED] |
| |o o| phone : (+39)-06-49914412 |
|--o00O-O00o-- fax : (+39)-06-49914423 (+39)-06-4957697 |
| address: Dipartimento di Fisica (V.E.) |
| Universita' di Roma "La Sapienza" |
| P.le Aldo Moro,5 I - 00185 Roma - Italy|
| gnupg pub. key: http://apegate.roma1.infn.it/~rossetti/gnupg.txt|
| |
|"Outside of a dog,a book is a man's best friend. Inside of a dog, |
| it's too dark to read." - Groucho Marx |
+------------------------------------------------------------------+
00:00.0 Host bridge: Intel Corporation 440BX/ZX - 82443BX/ZX Host bridge (rev 02)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort+ >SERR- <PERR-
Latency: 64
Region 0: Memory at f8000000 (32-bit, prefetchable)
Capabilities: [a0] AGP version 1.0
Status: RQ=31 SBA+ 64bit- FW- Rate=x1,x2
Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>
00:01.0 PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 02)
(prog-if 00 [Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV+ VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 128
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
Memory behind bridge: f0100000-f3ffffff
BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B+
00:05.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 41)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 165 (5000ns min, 10000ns max), cache line size 08
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at 1080
Region 1: Memory at f0000000 (32-bit, non-prefetchable)
00:06.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 41)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 165 (5000ns min, 10000ns max), cache line size 08
Interrupt: pin A routed to IRQ 5
Region 0: I/O ports at 1400
Region 1: Memory at f0000400 (32-bit, non-prefetchable)
00:07.0 ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 02)
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 0
00:07.1 IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 01) (prog-if 80
[Master])
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64
Region 4: I/O ports at 1050
00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01) (prog-if 00
[UHCI])
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin D routed to IRQ 9
Region 4: I/O ports at 1060
00:07.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 02)
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
00:08.0 PCI bridge: Digital Equipment Corporation DECchip 21154 (rev 02) (prog-if 00
[Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64, cache line size 08
Bus: primary=00, secondary=02, subordinate=02, sec-latency=68
Memory behind bridge: f4000000-f40fffff
BridgeCtl: Parity- SERR- NoISA+ VGA- MAbort- >Reset- FastB2B-
Capabilities: [dc] Power Management version 1
Flags: PMEClk- DSI- D1- D2- AuxCurrent=220mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Bridge: PM- B3+
00:0c.0 PCI bridge: Digital Equipment Corporation DECchip 21154 (rev 02) (prog-if 00
[Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64, cache line size 08
Bus: primary=00, secondary=03, subordinate=03, sec-latency=68
BridgeCtl: Parity- SERR- NoISA+ VGA- MAbort- >Reset- FastB2B-
Capabilities: [dc] Power Management version 1
Flags: PMEClk- DSI- D1- D2- AuxCurrent=220mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Bridge: PM- B3+
01:00.0 VGA compatible controller: Cirrus Logic GD 5465 [Laguna] (rev 03) (prog-if 00
[VGA])
Subsystem: Cirrus Logic GD 5465 [Laguna]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B-
Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 128 (4000ns min, 4000ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at f2000000 (32-bit, non-prefetchable)
Region 1: Memory at f0100000 (32-bit, non-prefetchable)
Capabilities: [80] AGP version 1.0
Status: RQ=0 SBA- 64bit- FW- Rate=<none>
Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>
02:09.0 IRDA controller: Unknown device aaaa:6666 (rev 01)
Subsystem: Technical Corp.: Unknown device abcd
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64 (8000ns max)
Interrupt: pin A routed to IRQ 10
Region 0: Memory at f4080000 (32-bit, non-prefetchable)
02:0c.0 Multimedia video controller: Unknown device aaaa:5555 (rev 01)
Subsystem: Technical Corp.: Unknown device abcd
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64 (8000ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at f4000000 (32-bit, non-prefetchable)
02:0d.0 Multimedia video controller: Unknown device aaaa:5555 (rev 01)
Subsystem: Technical Corp.: Unknown device abcd
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR+
Latency: 64 (8000ns max)
Interrupt: pin A routed to IRQ 10
Region 0: Memory at f4020000 (32-bit, non-prefetchable)
02:0e.0 Multimedia video controller: Unknown device aaaa:5555 (rev 01)
Subsystem: Technical Corp.: Unknown device abcd
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR+
Latency: 64 (8000ns max)
Interrupt: pin A routed to IRQ 5
Region 0: Memory at f4040000 (32-bit, non-prefetchable)
02:0f.0 Multimedia video controller: Unknown device aaaa:5555 (rev 01)
Subsystem: Technical Corp.: Unknown device abcd
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64 (8000ns max)
Interrupt: pin A routed to IRQ 9
Region 0: Memory at f4060000 (32-bit, non-prefetchable)
