On Wed, Jun 13, 2012 at 04:22:40PM +0800, Sonic Zhang wrote: > From: Michael Hennerich <michael.henner...@analog.com> > > For transfer counts > 255 bytes i2c-bfin-twi sets the data > transfer counter DCNT to 0xFF indicating unlimited transfers. > It then uses a flag iface->manual_stop to manually issue the STOP > condition, once the required amount of bytes are received. > > We found that on I2C receive operation issuing the STOP condition > together with a FULL RCV FIFO (2bytes) will cause SDA and SCL be > constantly driven low. > > Temporary workaround until further investigation: > Discard the RCV FIFO before issuing the STOP condition. > > Signed-off-by: Michael Hennerich <michael.henner...@analog.com> > Signed-off-by: Sonic Zhang <sonic.zh...@analog.com>
All 8 patches applied to next, thanks.
If you want to make my life easier, please state what changed from V1 to
V2. I had to look it up manually which costs time and doesn't make the
patchset look like a low-hanging fruit.
> ---
> drivers/i2c/busses/i2c-bfin-twi.c | 4 ++++
> 1 files changed, 4 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-bfin-twi.c
> b/drivers/i2c/busses/i2c-bfin-twi.c
> index cdb59e5..33031f0 100644
> --- a/drivers/i2c/busses/i2c-bfin-twi.c
> +++ b/drivers/i2c/busses/i2c-bfin-twi.c
> @@ -131,6 +131,10 @@ static void bfin_twi_handle_interrupt(struct
> bfin_twi_iface *iface,
> iface->transPtr++;
> iface->readNum--;
> } else if (iface->manual_stop) {
> + /* Temporary workaround to avoid possible bus stall -
> + * Flush FIFO before issuing the STOP condition
> + */
> + read_RCV_DATA16(iface);
> write_MASTER_CTL(iface,
> read_MASTER_CTL(iface) | STOP);
> } else if (iface->cur_mode == TWI_I2C_MODE_REPEAT &&
> --
> 1.7.0.4
>
>
--
Pengutronix e.K. | Wolfram Sang |
Industrial Linux Solutions | http://www.pengutronix.de/ |
signature.asc
Description: Digital signature
