On 31 Jan 01 at 8:44, David Woodhouse wrote:
> On Tue, 30 Jan 2001, Marcel J.E. Mol wrote:
>
> > Installed a Matrox G450 on my linux system. Now it has problems
> > booting.
> >
> > Previously I had a matrox G400 card and that worked without any problems.
> >
> > Below follows .config for the 2.4.0 kernel.
> >
> > # CONFIG_FB_MATROX_G450 is not set
It is only for secondary head support - and all code which is guarded
by this define is executed after lockup occurs, so no, it is not the
reason why it works / does not work...
If it helped you, I think that rule (4) from my another posting
applies to you - you are just lucky...
I asked matrox devrel again, but no answer. And linking matroxfb with
512KB binary-only mgaHALlib.a is unacceptable personally for me, not
even talking about license issues... (and not talking about technical
problems with getting mgaHALlib to work in kernel environment...)
Best regards,
Petr Vandrovec
[EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
