fec.c is only used on M68k Coldfire CPUs. Remove leftover
PowerPC code from this driver.
Signed-off-by: Jochen Friedrich <[EMAIL PROTECTED]>
---
drivers/net/fec.c | 136 +---------------------------------------------------
1 files changed, 3 insertions(+), 133 deletions(-)
diff --git a/drivers/net/fec.c b/drivers/net/fec.c
index 0fbf1bb..0499cbb 100644
--- a/drivers/net/fec.c
+++ b/drivers/net/fec.c
@@ -23,6 +23,9 @@
*
* Bug fixes and cleanup by Philippe De Muyter ([EMAIL PROTECTED])
* Copyright (c) 2004-2006 Macq Electronique SA.
+ *
+ * This driver is now only used on ColdFire processors. Remove conditional
+ * Powerpc code.
*/
#include <linux/module.h>
@@ -49,17 +52,9 @@
#include <asm/pgtable.h>
#include <asm/cacheflush.h>
-#if defined(CONFIG_M523x) || defined(CONFIG_M527x) || \
- defined(CONFIG_M5272) || defined(CONFIG_M528x) || \
- defined(CONFIG_M520x) || defined(CONFIG_M532x)
#include <asm/coldfire.h>
#include <asm/mcfsim.h>
#include "fec.h"
-#else
-#include <asm/8xx_immap.h>
-#include <asm/mpc8xx.h>
-#include "commproc.h"
-#endif
#if defined(CONFIG_FEC2)
#define FEC_MAX_PORTS 2
@@ -1223,14 +1218,9 @@ static phy_info_t const * const phy_info[] = {
/* ------------------------------------------------------------------------- */
#if !defined(CONFIG_M532x)
-#ifdef CONFIG_RPXCLASSIC
-static void
-mii_link_interrupt(void *dev_id);
-#else
static irqreturn_t
mii_link_interrupt(int irq, void * dev_id);
#endif
-#endif
#if defined(CONFIG_M5272)
/*
@@ -1800,121 +1790,6 @@ static void __inline__ fec_uncache(unsigned long addr)
/* ------------------------------------------------------------------------- */
-#else
-
-/*
- * Code specific to the MPC860T setup.
- */
-static void __inline__ fec_request_intrs(struct net_device *dev)
-{
- volatile immap_t *immap;
-
- immap = (immap_t *)IMAP_ADDR; /* pointer to internal registers */
-
- if (request_8xxirq(FEC_INTERRUPT, fec_enet_interrupt, 0, "fec", dev) !=
0)
- panic("Could not allocate FEC IRQ!");
-
-#ifdef CONFIG_RPXCLASSIC
- /* Make Port C, bit 15 an input that causes interrupts.
- */
- immap->im_ioport.iop_pcpar &= ~0x0001;
- immap->im_ioport.iop_pcdir &= ~0x0001;
- immap->im_ioport.iop_pcso &= ~0x0001;
- immap->im_ioport.iop_pcint |= 0x0001;
- cpm_install_handler(CPMVEC_PIO_PC15, mii_link_interrupt, dev);
-
- /* Make LEDS reflect Link status.
- */
- *((uint *) RPX_CSR_ADDR) &= ~BCSR2_FETHLEDMODE;
-#endif
-#ifdef CONFIG_FADS
- if (request_8xxirq(SIU_IRQ2, mii_link_interrupt, 0, "mii", dev) != 0)
- panic("Could not allocate MII IRQ!");
-#endif
-}
-
-static void __inline__ fec_get_mac(struct net_device *dev)
-{
- bd_t *bd;
-
- bd = (bd_t *)__res;
- memcpy(dev->dev_addr, bd->bi_enetaddr, ETH_ALEN);
-
-#ifdef CONFIG_RPXCLASSIC
- /* The Embedded Planet boards have only one MAC address in
- * the EEPROM, but can have two Ethernet ports. For the
- * FEC port, we create another address by setting one of
- * the address bits above something that would have (up to
- * now) been allocated.
- */
- dev->dev_adrd[3] |= 0x80;
-#endif
-}
-
-static void __inline__ fec_set_mii(struct net_device *dev, struct
fec_enet_private *fep)
-{
- extern uint _get_IMMR(void);
- volatile immap_t *immap;
- volatile fec_t *fecp;
-
- fecp = fep->hwp;
- immap = (immap_t *)IMAP_ADDR; /* pointer to internal registers */
-
- /* Configure all of port D for MII.
- */
- immap->im_ioport.iop_pdpar = 0x1fff;
-
- /* Bits moved from Rev. D onward.
- */
- if ((_get_IMMR() & 0xffff) < 0x0501)
- immap->im_ioport.iop_pddir = 0x1c58; /* Pre rev. D */
- else
- immap->im_ioport.iop_pddir = 0x1fff; /* Rev. D and later */
-
- /* Set MII speed to 2.5 MHz
- */
- fecp->fec_mii_speed = fep->phy_speed =
- ((bd->bi_busfreq * 1000000) / 2500000) & 0x7e;
-}
-
-static void __inline__ fec_enable_phy_intr(void)
-{
- volatile fec_t *fecp;
-
- fecp = fep->hwp;
-
- /* Enable MII command finished interrupt
- */
- fecp->fec_ivec = (FEC_INTERRUPT/2) << 29;
-}
-
-static void __inline__ fec_disable_phy_intr(void)
-{
-}
-
-static void __inline__ fec_phy_ack_intr(void)
-{
-}
-
-static void __inline__ fec_localhw_setup(void)
-{
- volatile fec_t *fecp;
-
- fecp = fep->hwp;
- fecp->fec_r_hash = PKT_MAXBUF_SIZE;
- /* Enable big endian and don't care about SDMA FC.
- */
- fecp->fec_fun_code = 0x78000000;
-}
-
-static void __inline__ fec_uncache(unsigned long addr)
-{
- pte_t *pte;
- pte = va_to_pte(mem_addr);
- pte_val(*pte) |= _PAGE_NO_CACHE;
- flush_tlb_page(init_mm.mmap, mem_addr);
-}
-
#endif
/* ------------------------------------------------------------------------- */
@@ -2126,13 +2001,8 @@ mii_discover_phy(uint mii_reg, struct net_device *dev)
/* This interrupt occurs when the PHY detects a link change.
*/
-#ifdef CONFIG_RPXCLASSIC
-static void
-mii_link_interrupt(void *dev_id)
-#else
static irqreturn_t
mii_link_interrupt(int irq, void * dev_id)
-#endif
{
struct net_device *dev = dev_id;
struct fec_enet_private *fep = netdev_priv(dev);
--
1.5.3.8
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
