On 4/16/2021 4:47 PM, Artur Petrosyan wrote:
> This move is done to call hibernation exit handler in
> "dwc2_port_resume()" function when core receives port resume.
> Otherwise it could be confusing to exit hibernation in
> "dwc2_hcd_hub_control()" function but other power saving modes
> in "dwc2_port_resume()" function.
> 
> Signed-off-by: Artur Petrosyan <arthur.petros...@synopsys.com>

Acked-by: Minas Harutyunyan <minas.harutyun...@synopsys.com>

> ---
>   Changes in v2:
>   - None
> 
>   drivers/usb/dwc2/hcd.c | 13 +++++++------
>   1 file changed, 7 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/usb/dwc2/hcd.c b/drivers/usb/dwc2/hcd.c
> index 43a2298b7d42..cc9ad6cf02d9 100644
> --- a/drivers/usb/dwc2/hcd.c
> +++ b/drivers/usb/dwc2/hcd.c
> @@ -3383,6 +3383,11 @@ int dwc2_port_resume(struct dwc2_hsotg *hsotg)
>                               "exit partial_power_down failed.\n");
>               break;
>       case DWC2_POWER_DOWN_PARAM_HIBERNATION:
> +             /* Exit host hibernation. */
> +             ret = dwc2_exit_hibernation(hsotg, 0, 0, 1);
> +             if (ret)
> +                     dev_err(hsotg->dev, "exit hibernation failed.\n");
> +             break;
>       case DWC2_POWER_DOWN_PARAM_NONE:
>               /*
>                * If not hibernation nor partial power down are supported,
> @@ -3446,12 +3451,8 @@ static int dwc2_hcd_hub_control(struct dwc2_hsotg 
> *hsotg, u16 typereq,
>                       dev_dbg(hsotg->dev,
>                               "ClearPortFeature USB_PORT_FEAT_SUSPEND\n");
>   
> -                     if (hsotg->bus_suspended) {
> -                             if (hsotg->hibernated)
> -                                     dwc2_exit_hibernation(hsotg, 0, 0, 1);
> -                             else
> -                                     dwc2_port_resume(hsotg);
> -                     }
> +                     if (hsotg->bus_suspended)
> +                             retval = dwc2_port_resume(hsotg);
>                       break;
>   
>               case USB_PORT_FEAT_POWER:
> 

Reply via email to