Hi Xiaofeng Cao,

The patch is good, but scripts/checkpatch.pl complains about a mismatch:

WARNING: From:/Signed-off-by: email address mismatch: 'From: Xiaofeng Cao 
<cxfcos...@gmail.com>' != 'Signed-off-by: Xiaofeng Cao
<caoxiaof...@yulong.com>'

Which is the one I should use?

Regards,

        Hans

On 11/03/2021 08:20, Xiaofeng Cao wrote:
> Change 'inaccesable' to 'inaccessible'
> Change 'detrmine' to 'determine'
> Delete 'in' grammatically
> 
> Signed-off-by: Xiaofeng Cao <caoxiaof...@yulong.com>
> ---
>  drivers/media/radio/radio-si476x.c | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/media/radio/radio-si476x.c 
> b/drivers/media/radio/radio-si476x.c
> index 23997425bdb5..b39a68f83c5f 100644
> --- a/drivers/media/radio/radio-si476x.c
> +++ b/drivers/media/radio/radio-si476x.c
> @@ -152,7 +152,7 @@ static struct v4l2_ctrl_config si476x_ctrls[] = {
>  
>       /*
>        * SI476X during its station seeking(or tuning) process uses several
> -      * parameters to detrmine if "the station" is valid:
> +      * parameters to determine if "the station" is valid:
>        *
>        *      - Signal's SNR(in dBuV) must be lower than
>        *      #V4L2_CID_SI476X_SNR_THRESHOLD
> @@ -255,7 +255,7 @@ struct si476x_radio;
>   *
>   * This table holds pointers to functions implementing particular
>   * operations depending on the mode in which the tuner chip was
> - * configured to start in. If the function is not supported
> + * configured to start. If the function is not supported
>   * corresponding element is set to #NULL.
>   *
>   * @tune_freq: Tune chip to a specific frequency
> @@ -917,7 +917,7 @@ static int si476x_radio_s_ctrl(struct v4l2_ctrl *ctrl)
>       case V4L2_CID_RDS_RECEPTION:
>               /*
>                * It looks like RDS related properties are
> -              * inaccesable when tuner is in AM mode, so cache the
> +              * inaccessible when tuner is in AM mode, so cache the
>                * changes
>                */
>               if (si476x_core_is_in_am_receiver_mode(radio->core))
> 

Reply via email to