On 3/11/21 3:41 PM, Ahmad Fatoum wrote:
Hello,
Hi,
On 11.03.21 15:02, Alexandre TORGUE wrote:
On 3/11/21 12:43 PM, Marek Vasut wrote:
On 3/11/21 9:08 AM, Alexandre TORGUE wrote:
1- Break the current ABI: as soon as those patches are merged,
stm32mp157c-dk2.dtb will impose to use
A tf-a for scmi clocks. For people using u-boot spl, the will have to create their own
"no-secure" devicetree.
NAK, this breaks existing boards and existing setups, e.g. DK2 that does not
use ATF.
2-As you suggest, create a new "secure" dtb per boards (Not my wish for
maintenance perspectives).
I agree with Alex (G) that the "secure" option should be opt-in.
That way existing setups remain working and no extra requirements are imposed on MP1
users. Esp. since as far as I understand this, the "secure" part isn't really
about security, but rather about moving clock configuration from Linux to some firmware
blob.
3- Keep kernel device tree as they are and applied this secure layer (scmi
clocks phandle) thanks to dtbo in
U-boot.
Is this really better than
#include "stm32mp15xx-enable-secure-stuff.dtsi"
in a board DT ? Because that is how I imagine the opt-in "secure" option could
work.
Discussing with Patrick about u-boot, we could use dtbo application thanks to extlinux.conf.
BUT it it will not prevent other case (i.e. TF-A which jump directly in kernel@). So the
"least worst" solution is to create a new "stm32mp1257c-scmi-dk2 board which
will overload clock entries with a scmi phandle (as proposed by Alex).
I raised this issue before with your colleagues. I still believe the correct way
would be for the TF-A to pass down either a device tree or an overlay with the
actual settings in use, e.g.:
- Clocks/Resets done via SCMI
- Reserved memory regions
If TF-A directly boots Linux, it can apply the overlay itself, otherwise it's
passed down to SSBL that applies it before booting Linux.
That sounds good and it is something e.g. R-Car already does, it merges
DT fragment from prior stages at U-Boot level and then passes the result
to Linux.
So on ST hardware, the same could very well happen and it would work for
both non-ATF / ATF / ATF+TEE options.
