On Mon, 07 Jan 2008 20:38:09 +0100 Bodo Eggert <[EMAIL PROTECTED]> wrote:
> Christer Weinigel <[EMAIL PROTECTED]> wrote: > > > How do you find out the speed of the ISA bus? AFAIK there is no > > standardized way to do that. On the Geode SC2200 the ISA bus speed > > is usually the PCI clock divided by 4 giving 33MHz/4=8.3MHz or > > 30/4=7.5MHz, but with no external ISA devices it's possible to > > overclock the ISA bus to /3 to run it at 11MHz or so. But without > > poking at some CPU and southbridge specific registers to find out > > the PCI bus speed and the ISA bus divisor you can't really tell. > > If you overclock, you are on your own. IIRC I've used 13,3 MHz for > some time and used a lower PIO mode to compensate. That would not be overclocking, rather that the hardware designer would have determined that on that specific hardware design, all peripherals are able to run at 12MHz. Also note that on some other system the hardware designer might have decided to have a slower ISA clock, to save power, fulfil some EMI requirement or whatever. > > So if you do udelay based on a 6MHz clock (I think you can safely > > assume that any 386 based system runs the ISA bus at least that > > fast) you'll waste at least 30% and maybe even 100% more time for > > the delay after every _p call. > > Defaulting to 8 MHz and offering an option to set another clock speed > (like idebus=) should be OK. Sounds like a big regression to have to start using a command line option, when the current state of affairs is "it just works". /Christer -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/