Dear Guoqing,
On 26.01.21 15:06, Guoqing Jiang wrote:
On 1/26/21 13:58, Donald Buczek wrote:
Hmm, how about wake the waiter up in the while loop of raid5d?
@@ -6520,6 +6532,11 @@ static void raid5d(struct md_thread *thread)
md_check_recovery(mddev);
spin_lock_irq(&conf->device_lock);
}
+
+ if ((atomic_read(&conf->active_stripes)
+ < (conf->max_nr_stripes * 3 / 4) ||
+ (test_bit(MD_RECOVERY_INTR, &mddev->recovery))))
+ wake_up(&conf->wait_for_stripe);
}
pr_debug("%d stripes handled\n", handled);
Hmm... With this patch on top of your other one, we still have the basic
symptoms (md3_raid6 busy looping), but the sync thread is now hanging at
root@sloth:~# cat /proc/$(pgrep md3_resync)/stack
[<0>] md_do_sync.cold+0x8ec/0x97c
[<0>] md_thread+0xab/0x160
[<0>] kthread+0x11b/0x140
[<0>] ret_from_fork+0x22/0x30
instead, which is
https://elixir.bootlin.com/linux/latest/source/drivers/md/md.c#L8963
Not sure why recovery_active is not zero, because it is set 0 before
blk_start_plug, and raid5_sync_request returns 0 and skipped is also set to 1.
Perhaps handle_stripe calls md_done_sync.
Could you double check the value of recovery_active? Or just don't wait if
resync thread is interrupted.
wait_event(mddev->recovery_wait,
test_bit(MD_RECOVERY_INTR,&mddev->recovery) ||
!atomic_read(&mddev->recovery_active));
With that added, md3_resync goes into a loop, too. Not 100% busy, though.
root@sloth:~# cat /proc/$(pgrep md3_resync)/stack
[<0>] raid5_get_active_stripe+0x1e7/0x6b0 #
https://elixir.bootlin.com/linux/v5.11-rc5/source/drivers/md/raid5.c#L735
[<0>] raid5_sync_request+0x2a7/0x3d0 #
https://elixir.bootlin.com/linux/v5.11-rc5/source/drivers/md/raid5.c#L6274
[<0>] md_do_sync.cold+0x3ee/0x97c #
https://elixir.bootlin.com/linux/v5.11-rc5/source/drivers/md/md.c#L8883
[<0>] md_thread+0xab/0x160
[<0>] kthread+0x11b/0x140
[<0>] ret_from_fork+0x22/0x30
Sometimes top of stack is raid5_get_active_stripe+0x1ef/0x6b0 instead of
raid5_get_active_stripe+0x1e7/0x6b0, so I guess it sleeps, its woken, but the
conditions don't match so its sleeps again.
Best
Donald
And, unlike before, "md: md3: data-check interrupted." from the pr_info two
lines above appears in dmesg.
Yes, that is intentional since MD_RECOVERY_INTR is set by write idle.
Anyway, will try the script and investigate more about the issue.
Thanks,
Guoqing
--
Donald Buczek
buc...@molgen.mpg.de
Tel: +49 30 8413 1433
