I'm currently experiencing difficulty booting Linux 2.4.0 on a Compaq
1850R server with a SMART 3200 controller on board.
When the SMART array is detected and the cpqarray driver is loaded,
the system hangs at the following point:
Compaq SMART2 Driver (v 2.4.1)
Found 1 controller(s)
cpqarray ida/c0d0: blksz=512 nr_blks=17764320
Partition check:
ida/c0d0:_
The partition check never starts.
I get the same results when booting 2.4.1-pre8. The system works fine
with the 2.2.x kernel series, but I need some of the functionality in
the newer 2.4.x series.
Any ideas?
Ian
--
Ian Macdonald | Inspite of all evidence to the contrary,
Senior System Administrator | the entire universe is composed of only two
Linuxcare, Inc. | basic substances: magic and bullshit.
Support for the Revolution |
|
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
