On Wed, 17 Jan 2001, Dominik Kubla wrote:
> Just switched to 2.4.0-ac9 (+crypto patches) on our Dual-Pentium MMX
> webserver yesterday. Works fine so far, except i keep seeing those
> APIC erros (about 14 in 12 hrs) indicating receive, send and CS errors.
>
> Should i be concerned?
At this volume I would treat this as a warning but not a critical issue.
Inter-APIC messages get retransmitted in case of an error, but the
checksum circuit is not sophisticated -- a double-bit error might pass
unnoticed leading to a system unstability under certain conditions. At
such a low volume of errors double-bit ones are not likely to happen.
It's the first report of APIC errors on a P5 system I have seen, so it's
probably not a result of a bad motherboard design. I'd recommend to check
if the system doesn't get overheated. You may also be unlucky to have a
faulty board.
Maciej
--
+ Maciej W. Rozycki, Technical University of Gdansk, Poland +
+--------------------------------------------------------------+
+ e-mail: [EMAIL PROTECTED], PGP key available +
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
