[PATCH] pinctrl: bcm: pinctrl-nsp-gpio: Fix setting GPIO as output

[Mark Tomlinson]

When setting a GPIO pin to an output, it is important to set the value
correctly before enabling the output so that a glitch is not seen on the
pin. This glitch may be very short, but can be important if this is a
reset signal.

Fixes: 8bfcbbbcabe0 ("pinctrl: nsp: add gpio-a driver support for Broadcom NSP 
SoC")
Signed-off-by: Mark Tomlinson <mark.tomlin...@alliedtelesis.co.nz>
---
 drivers/pinctrl/bcm/pinctrl-nsp-gpio.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c 
b/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
index a00a42a61a90..942f04ca4868 100644
--- a/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
+++ b/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
@@ -289,8 +289,8 @@ static int nsp_gpio_direction_output(struct gpio_chip *gc, 
unsigned gpio,
        unsigned long flags;
 
        raw_spin_lock_irqsave(&chip->lock, flags);
-       nsp_set_bit(chip, REG, NSP_GPIO_OUT_EN, gpio, true);
        nsp_set_bit(chip, REG, NSP_GPIO_DATA_OUT, gpio, !!(val));
+       nsp_set_bit(chip, REG, NSP_GPIO_OUT_EN, gpio, true);
        raw_spin_unlock_irqrestore(&chip->lock, flags);
 
        dev_dbg(chip->dev, "gpio:%u set output, value:%d\n", gpio, val);
-- 
2.29.2