[PATCH] pinctrl: bcm: pinctrl-iproc-gpio: Fix setting GPIO as output

[Mark Tomlinson]

When setting a GPIO pin to an output, it is important to set the value
correctly before enabling the output so that a glitch is not seen on the
pin. This glitch may be very short, but can be important if this is a
reset signal.

Fixes: b64333ce769c ("pinctrl: cygnus: add gpio/pinconf driver")
Signed-off-by: Mark Tomlinson <mark.tomlin...@alliedtelesis.co.nz>
---
 drivers/pinctrl/bcm/pinctrl-iproc-gpio.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pinctrl/bcm/pinctrl-iproc-gpio.c 
b/drivers/pinctrl/bcm/pinctrl-iproc-gpio.c
index e2bd2dce6bb4..cadcf5eb0466 100644
--- a/drivers/pinctrl/bcm/pinctrl-iproc-gpio.c
+++ b/drivers/pinctrl/bcm/pinctrl-iproc-gpio.c
@@ -348,8 +348,8 @@ static int iproc_gpio_direction_output(struct gpio_chip 
*gc, unsigned gpio,
        unsigned long flags;
 
        raw_spin_lock_irqsave(&chip->lock, flags);
-       iproc_set_bit(chip, IPROC_GPIO_OUT_EN_OFFSET, gpio, true);
        iproc_set_bit(chip, IPROC_GPIO_DATA_OUT_OFFSET, gpio, !!(val));
+       iproc_set_bit(chip, IPROC_GPIO_OUT_EN_OFFSET, gpio, true);
        raw_spin_unlock_irqrestore(&chip->lock, flags);
 
        dev_dbg(chip->dev, "gpio:%u set output, value:%d\n", gpio, val);
-- 
2.29.2