Currently driver only retries to download FW if FW downloading
is failed. Sometimes observed command timeout for version request
command, if this happen on some platforms during boot time, then
a reboot is needed to turn ON BT. Instead to avoid a reboot, now
extended retry logic for version request command too.
Signed-off-by: Balakrishna Godavarthi <bgoda...@codeaurora.org>
---
drivers/bluetooth/hci_qca.c | 34 ++++++++++++++++++----------------
1 file changed, 18 insertions(+), 16 deletions(-)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 2d3f1f1..1c9a2d46 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1672,7 +1672,7 @@ static int qca_setup(struct hci_uart *hu)
retry:
ret = qca_power_on(hdev);
if (ret)
- return ret;
+ goto out;
clear_bit(QCA_SSR_TRIGGERED, &qca->flags);
@@ -1681,7 +1681,7 @@ static int qca_setup(struct hci_uart *hu)
ret = qca_read_soc_version(hdev, &soc_ver, soc_type);
if (ret)
- return ret;
+ goto out;
} else {
qca_set_speed(hu, QCA_INIT_SPEED);
}
@@ -1691,7 +1691,7 @@ static int qca_setup(struct hci_uart *hu)
if (speed) {
ret = qca_set_speed(hu, QCA_OPER_SPEED);
if (ret)
- return ret;
+ goto out;
qca_baudrate = qca_get_baudrate_value(speed);
}
@@ -1700,7 +1700,7 @@ static int qca_setup(struct hci_uart *hu)
/* Get QCA version information */
ret = qca_read_soc_version(hdev, &soc_ver, soc_type);
if (ret)
- return ret;
+ goto out;
}
bt_dev_info(hdev, "QCA controller version 0x%08x", soc_ver);
@@ -1721,20 +1721,22 @@ static int qca_setup(struct hci_uart *hu)
* patch/nvm-config is found, so run with original fw/config.
*/
ret = 0;
- } else {
- if (retries < MAX_INIT_RETRIES) {
- qca_power_shutdown(hu);
- if (hu->serdev) {
- serdev_device_close(hu->serdev);
- ret = serdev_device_open(hu->serdev);
- if (ret) {
- bt_dev_err(hdev, "failed to open port");
- return ret;
- }
+ }
+
+out:
+ if (ret && retries < MAX_INIT_RETRIES) {
+ bt_dev_warn(hdev, "Retry BT power ON:%d", retries);
+ qca_power_shutdown(hu);
+ if (hu->serdev) {
+ serdev_device_close(hu->serdev);
+ ret = serdev_device_open(hu->serdev);
+ if (ret) {
+ bt_dev_err(hdev, "failed to open port");
+ return ret;
}
- retries++;
- goto retry;
}
+ retries++;
+ goto retry;
}
/* Setup bdaddr */
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
