Hi Prabhakar,

Can you rebase this patch? It no longer applies.

Regards,

        Hans

On 13/09/2020 20:16, Lad Prabhakar wrote:
> Enable YDS bit if bus_width and data_shift is set to 8 in parallel mode
> for MEDIA_BUS_FMT_UYVY8_2X8 format.
> 
> Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad...@bp.renesas.com>
> Reviewed-by: Biju Das <biju.das...@bp.renesas.com>
> ---
> Changes for v3:
> * Dropped BIT macro
> * Introduced struct v4l2_fwnode_bus_parallel
> 
> Changes for v2:
> * Dropped DT binding documentation patch
> * Select the data pins depending on bus-width and data-shift
> 
> v1 -
> https://patchwork.kernel.org/project/linux-renesas-soc/list/?series=323799
> ---
>  drivers/media/platform/rcar-vin/rcar-core.c |  9 ++++-----
>  drivers/media/platform/rcar-vin/rcar-dma.c  | 17 ++++++++++++++---
>  drivers/media/platform/rcar-vin/rcar-vin.h  |  5 +++--
>  3 files changed, 21 insertions(+), 10 deletions(-)
> 
> diff --git a/drivers/media/platform/rcar-vin/rcar-core.c 
> b/drivers/media/platform/rcar-vin/rcar-core.c
> index 7440c8965d27..1149ab76cf5c 100644
> --- a/drivers/media/platform/rcar-vin/rcar-core.c
> +++ b/drivers/media/platform/rcar-vin/rcar-core.c
> @@ -626,12 +626,11 @@ static int rvin_parallel_parse_v4l2(struct device *dev,
>  
>       switch (vin->parallel->mbus_type) {
>       case V4L2_MBUS_PARALLEL:
> -             vin_dbg(vin, "Found PARALLEL media bus\n");
> -             vin->parallel->mbus_flags = vep->bus.parallel.flags;
> -             break;
>       case V4L2_MBUS_BT656:
> -             vin_dbg(vin, "Found BT656 media bus\n");
> -             vin->parallel->mbus_flags = 0;
> +             vin_dbg(vin, "Found %s media bus\n",
> +                     vin->parallel->mbus_type == V4L2_MBUS_PARALLEL ?
> +                     "PARALLEL" : "BT656");
> +             vin->parallel->bus = vep->bus.parallel;
>               break;
>       default:
>               vin_err(vin, "Unknown media bus type\n");
> diff --git a/drivers/media/platform/rcar-vin/rcar-dma.c 
> b/drivers/media/platform/rcar-vin/rcar-dma.c
> index a5dbb90c5210..d067439b0b0d 100644
> --- a/drivers/media/platform/rcar-vin/rcar-dma.c
> +++ b/drivers/media/platform/rcar-vin/rcar-dma.c
> @@ -125,6 +125,7 @@
>  #define VNDMR2_VPS           (1 << 30)
>  #define VNDMR2_HPS           (1 << 29)
>  #define VNDMR2_CES           (1 << 28)
> +#define VNDMR2_YDS           (1 << 22)
>  #define VNDMR2_FTEV          (1 << 17)
>  #define VNDMR2_VLV(n)                ((n & 0xf) << 12)
>  
> @@ -698,16 +699,26 @@ static int rvin_setup(struct rvin_dev *vin)
>  
>       if (!vin->is_csi) {
>               /* Hsync Signal Polarity Select */
> -             if (!(vin->parallel->mbus_flags & V4L2_MBUS_HSYNC_ACTIVE_LOW))
> +             if (!(vin->parallel->bus.flags & V4L2_MBUS_HSYNC_ACTIVE_LOW))
>                       dmr2 |= VNDMR2_HPS;
>  
>               /* Vsync Signal Polarity Select */
> -             if (!(vin->parallel->mbus_flags & V4L2_MBUS_VSYNC_ACTIVE_LOW))
> +             if (!(vin->parallel->bus.flags & V4L2_MBUS_VSYNC_ACTIVE_LOW))
>                       dmr2 |= VNDMR2_VPS;
>  
>               /* Data Enable Polarity Select */
> -             if (vin->parallel->mbus_flags & V4L2_MBUS_DATA_ENABLE_LOW)
> +             if (vin->parallel->bus.flags & V4L2_MBUS_DATA_ENABLE_LOW)
>                       dmr2 |= VNDMR2_CES;
> +
> +             switch (vin->mbus_code) {
> +             case MEDIA_BUS_FMT_UYVY8_2X8:
> +                     if (vin->parallel->bus.bus_width == 8 &&
> +                         vin->parallel->bus.data_shift == 8)
> +                             dmr2 |= VNDMR2_YDS;
> +                     break;
> +             default:
> +                     break;
> +             }
>       }
>  
>       /*
> diff --git a/drivers/media/platform/rcar-vin/rcar-vin.h 
> b/drivers/media/platform/rcar-vin/rcar-vin.h
> index c19d077ce1cb..8396e0e45478 100644
> --- a/drivers/media/platform/rcar-vin/rcar-vin.h
> +++ b/drivers/media/platform/rcar-vin/rcar-vin.h
> @@ -19,6 +19,7 @@
>  #include <media/v4l2-ctrls.h>
>  #include <media/v4l2-dev.h>
>  #include <media/v4l2-device.h>
> +#include <media/v4l2-fwnode.h>
>  #include <media/videobuf2-v4l2.h>
>  
>  /* Number of HW buffers */
> @@ -92,7 +93,7 @@ struct rvin_video_format {
>   * @asd:     sub-device descriptor for async framework
>   * @subdev:  subdevice matched using async framework
>   * @mbus_type:       media bus type
> - * @mbus_flags:      media bus configuration flags
> + * @bus:     media bus parallel configuration
>   * @source_pad:      source pad of remote subdevice
>   * @sink_pad:        sink pad of remote subdevice
>   *
> @@ -102,7 +103,7 @@ struct rvin_parallel_entity {
>       struct v4l2_subdev *subdev;
>  
>       enum v4l2_mbus_type mbus_type;
> -     unsigned int mbus_flags;
> +     struct v4l2_fwnode_bus_parallel bus;
>  
>       unsigned int source_pad;
>       unsigned int sink_pad;
> 

Reply via email to