This patch does fix potential NULL pointer dereference
that could take place inside of strcmp() if
of_get_property() call failed.
Signed-off-by: Cyrill Gorcunov <[EMAIL PROTECTED]>
---
arch/powerpc/platforms/83xx/usb.c | 8 ++++----
1 files changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/powerpc/platforms/83xx/usb.c
b/arch/powerpc/platforms/83xx/usb.c
index eafe760..b45160f 100644
--- a/arch/powerpc/platforms/83xx/usb.c
+++ b/arch/powerpc/platforms/83xx/usb.c
@@ -130,7 +130,7 @@ int mpc831x_usb_cfg(void)
out_be32(immap + MPC83XX_SCCR_OFFS, temp);
/* Configure pin mux for ULPI. There is no pin mux for UTMI */
- if (!strcmp(prop, "ulpi")) {
+ if (prop && !strcmp(prop, "ulpi")) {
temp = in_be32(immap + MPC83XX_SICRL_OFFS);
temp &= ~MPC831X_SICRL_USB_MASK;
temp |= MPC831X_SICRL_USB_ULPI;
@@ -153,13 +153,13 @@ int mpc831x_usb_cfg(void)
usb_regs = ioremap(res.start, res.end - res.start + 1);
/* Using on-chip PHY */
- if (!strcmp(prop, "utmi_wide") ||
- !strcmp(prop, "utmi")) {
+ if (prop && (!strcmp(prop, "utmi_wide") ||
+ !strcmp(prop, "utmi"))) {
/* Set UTMI_PHY_EN, REFSEL to 48MHZ */
out_be32(usb_regs + FSL_USB2_CONTROL_OFFS,
CONTROL_UTMI_PHY_EN | CONTROL_REFSEL_48MHZ);
/* Using external UPLI PHY */
- } else if (!strcmp(prop, "ulpi")) {
+ } else if (prop && !strcmp(prop, "ulpi")) {
/* Set PHY_CLK_SEL to ULPI */
temp = CONTROL_PHY_CLK_SEL_ULPI;
#ifdef CONFIG_USB_OTG
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
