On Thu, 2020-07-09 at 18:45 +0100, Lee Jones wrote:
> Haven't been used since 2006.
> 
> Fixes the following W=1 kernel build warning(s):
> 
>  drivers/scsi/aic7xxx/aic79xx_osm.c: In function
> ‘ahd_linux_queue_abort_cmd’:
>  drivers/scsi/aic7xxx/aic79xx_osm.c:2155:17: warning: variable
> ‘saved_modes’ set but not used [-Wunused-but-set-variable]
>  drivers/scsi/aic7xxx/aic79xx_osm.c:2148:9: warning: variable
> ‘saved_scsiid’ set but not used [-Wunused-but-set-variable]
> 
> Cc: Hannes Reinecke <h...@suse.com>
> Signed-off-by: Lee Jones <lee.jo...@linaro.org>
> ---
>  drivers/scsi/aic7xxx/aic79xx_osm.c | 6 ++----
>  1 file changed, 2 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/scsi/aic7xxx/aic79xx_osm.c
> b/drivers/scsi/aic7xxx/aic79xx_osm.c
> index 3782a20d58885..b0c6701f64a83 100644
> --- a/drivers/scsi/aic7xxx/aic79xx_osm.c
> +++ b/drivers/scsi/aic7xxx/aic79xx_osm.c
> @@ -2141,14 +2141,12 @@ ahd_linux_queue_abort_cmd(struct scsi_cmnd
> *cmd)
>       u_int  saved_scbptr;
>       u_int  active_scbptr;
>       u_int  last_phase;
> -     u_int  saved_scsiid;
>       u_int  cdb_byte;
>       int    retval;
>       int    was_paused;
>       int    paused;
>       int    wait;
>       int    disconnected;
> -     ahd_mode_state saved_modes;
>       unsigned long flags;
>  
>       pending_scb = NULL;
> @@ -2239,7 +2237,7 @@ ahd_linux_queue_abort_cmd(struct scsi_cmnd
> *cmd)
>               goto done;
>       }
>  
> -     saved_modes = ahd_save_modes(ahd);
> +     ahd_save_modes(ahd);

Well, this is clearly wrong, since ahd_save_modes has no side effects.

However, I think it also means there's a bug in this code:

>       ahd_set_modes(ahd, AHD_MODE_SCSI, AHD_MODE_SCSI);

You can't do this without later restoring the mode, so someone needs to
figure out where the missing ahd_restore_modes() should go.

>       last_phase = ahd_inb(ahd, LASTPHASE);
>       saved_scbptr = ahd_get_scbptr(ahd);
> @@ -2257,7 +2255,7 @@ ahd_linux_queue_abort_cmd(struct scsi_cmnd
> *cmd)
>        * passed in command.  That command is currently active on
> the
>        * bus or is in the disconnected state.
>        */
> -     saved_scsiid = ahd_inb(ahd, SAVED_SCSIID);
> +     ahd_inb(ahd, SAVED_SCSIID);

I think this can just go.

James

Reply via email to