On 09-07-20, 07:02, Swapnil Kashinath Jakhade wrote: > Ping requesting review comments. > https://lkml.org/lkml/2020/5/26/507
I dont have this, can you repost? Thanks > > Thanks & regards, > Swapnil > > > -----Original Message----- > > From: Yuti Amonkar <yamon...@cadence.com> > > Sent: Tuesday, May 26, 2020 8:05 PM > > To: linux-kernel@vger.kernel.org; kis...@ti.com; robh...@kernel.org; > > mark.rutl...@arm.com; max...@cerno.tech > > Cc: nsek...@ti.com; jsa...@ti.com; tomi.valkei...@ti.com; > > prane...@ti.com; Milind Parab <mpa...@cadence.com>; Swapnil Kashinath > > Jakhade <sjakh...@cadence.com>; Yuti Suresh Amonkar > > <yamon...@cadence.com> > > Subject: [PATCH v2 0/2] Add support to get/set PHY attributes using PHY > > framework > > > > This patch series adds support to use kernel PHY subsystem APIs to get/set > > PHY attributes like number of lanes and maximum link rate. > > > > It includes following patches: > > > > 1. v2-0001-phy-Add-max_link_rate-as-a-PHY-attribute-and-APIs.patch > > This patch adds max_link_rate as a PHY attribute along with a pair of APIs > > that allow the generic PHY subsystem to get/set PHY attributes supported by > > the PHY. > > The PHY provider driver may use phy_set_attrs() API to set the values that > > PHY supports. > > The controller driver may then use phy_get_attrs() API to fetch the PHY > > attributes in order to properly configure the controller. > > > > 2. v2-0002-phy-phy-cadence-torrent-Use-kernel-PHY-API-to-set.patch > > This patch uses kernel PHY API phy_set_attrs to set corresponding PHY > > properties in Cadence Torrent PHY driver. This will enable drivers using > > this > > PHY to read these properties using PHY framework. > > > > The phy_get_attrs() API will be used in the DRM bridge driver [1] which is > > in > > process of upstreaming. > > > > [1] > > > > https://lkml.org/lkml/2020/2/26/263 > > > > Version History: > > > > v2: > > - Implemented single pair of functions to get/set all PHY attributes > > > > Swapnil Jakhade (1): > > phy: phy-cadence-torrent: Use kernel PHY API to set PHY attributes > > > > Yuti Amonkar (1): > > phy: Add max_link_rate as a PHY attribute and APIs to get/set > > phy_attrs > > > > drivers/phy/cadence/phy-cadence-torrent.c | 7 +++++++ > > include/linux/phy/phy.h | 25 +++++++++++++++++++++++ > > 2 files changed, 32 insertions(+) > > > > -- > > 2.17.1 -- ~Vinod
