On 17.06.20 09:38, Martin Kepplinger wrote:
> From: "Angus Ainslie (Purism)" <an...@akkea.ca>
>
> Add a devicetree description for the Librem 5 phone. The early batches
> that have been sold are supported as well as the mass-produced device
> available later this year, see https://puri.sm/products/librem-5/
>
> This boots to a working console with working WWAN modem, wifi usdhc,
> IMU sensor device, proximity sensor, haptic motor, gpio keys, GNSS and LEDs.
>
> Signed-off-by: Martin Kepplinger <martin.kepplin...@puri.sm>
> Signed-off-by: Angus Ainslie (Purism) <an...@akkea.ca>
> Signed-off-by: Guido Günther <a...@sigxcpu.org>
> For audio related part:
> Reviewed-by: Daniel Baluta <daniel.bal...@nxp.com>
> ---
>
> revision history
> ----------------
> v3:
> thanks a lot Mark for reviewing! changes since v2:
> * nicer audio cards names
> * squash unneeded audio_pwr regulator
> * remove the unneeded susphy_quirk from dwc3_1 after more testing
> * add usdhc2 card detect via gpio
> * add headphone detect for audio card
>
> v2:
> thanks a lot Marco, Daniel and Pavel for reviewing. changes since v1:
> * alphabetical sortings / more consistent node names
> * remove unused regulator and pinctrl descriptions
> * generic labels for leds, backlight, flash and torch
> * audio clk settings moved to sai2 node
> https://lore.kernel.org/linux-arm-kernel/20200604084756.586-1-martin.kepplin...@puri.sm/T/
>
> v1:
> https://lore.kernel.org/linux-arm-kernel/20200514155737.12160-1-martin.kepplin...@puri.sm/
>
>
>
> arch/arm64/boot/dts/freescale/Makefile | 1 +
> .../boot/dts/freescale/imx8mq-librem5.dts | 1137 +++++++++++++++++
> 2 files changed, 1138 insertions(+)
> create mode 100644 arch/arm64/boot/dts/freescale/imx8mq-librem5.dts
>
again thanks for reviewing so far. do you have any other objections or
thoughts on this addition?
martin
