On 10/16/2007 10:50 AM, Dave Johnson wrote:
> From: Dave Johnson <[EMAIL PROTECTED]>
>
> I ran into this problem on a system that was unable to obtain NTP sync
> because the clock was running very slow (over 10000ppm slow). ntpd had
> declared all of its peers 'reject' with 'peer_dist' reason.
>
> On investigation, the tsc_khz variable was significantly incorrect
> causing xtime to run slow. After a reboot tsc_khz was correct so I
> did a reboot test to see how often the problem occurred:
>
> Test was done on a 2000 Mhz Xeon system. Of 689 reboots, 8 of them
> had unacceptable tsc_khz values (>500ppm):
>
> range of tsc_khz # of boots % of boots
> ----------------- ---------- ----------
> < 1999750 0 0.000%
> 1999750 - 1999800 21 3.048%
> 1999800 - 1999850 166 24.128%
> 1999850 - 1999900 241 35.029%
> 1999900 - 1999950 211 30.669%
> 1999950 - 2000000 42 6.105%
> 2000000 - 2000000 0 0.000%
> 2000050 - 2000100 0 0.000%
> [...]
> 2000100 - 2015000 1 0.145% << BAD
> 2015000 - 2030000 6 0.872% << BAD
> 2030000 - 2045000 1 0.145% << BAD
> 2045000 < 0 0.000%
>
> The worst boot was 2032.577 Mhz, over 1.5% off!
>
> It appears that on rare occasions, mach_countup() is taking longer to
> complete than necessary.
>
> I suspect that this is caused by the CPU taking a periodic SMI
> interrupt right at the end of the 30ms calibration loop. This would
> cause the loop to delay while the SMI BIOS hander runs. The resulting
> TSC value is beyond what it actually should be resulting in a higher
> tsc_khz.
>
> The below patch makes native_calculate_cpu_khz() take the best
> (shortest duration, lowest khz) run of it's 3 calibration loops. If a
> SMI goes off causing a bad result (long duration, higher khz) it will
> be discarded.
>
> With the patch applied, 300 boots of the same system produce good
> results:
>
> range of tsc_khz # of boots % of boots
> ----------------- ---------- ----------
> < 1999750 0 0.000%
> 1999750 - 1999800 30 10.000%
> 1999800 - 1999850 166 55.333%
> 1999850 - 1999900 89 29.667%
> 1999900 - 1999950 15 5.000%
> 1999950 < 0 0.000%
>
> Problem was found and tested against 2.6.18. Patch is against 2.6.22.
>
> Signed-off-by: Dave Johnson <[EMAIL PROTECTED]>
>
> ===== arch/i386/kernel/tsc.c 1.27 vs edited =====
> --- 1.27/arch/i386/kernel/tsc.c 2007-05-02 13:27:18 -04:00
> +++ edited/arch/i386/kernel/tsc.c 2007-10-15 16:31:04 -04:00
> @@ -122,7 +122,7 @@
> {
> unsigned long long start, end;
> unsigned long count;
> - u64 delta64;
> + u64 delta64 = (u64)ULLONG_MAX;
> int i;
> unsigned long flags;
>
> @@ -134,6 +134,7 @@
> rdtscll(start);
> mach_countup(&count);
> rdtscll(end);
> + delta64 = min(delta64, (end - start));
> }
> /*
> * Error: ECTCNEVERSET
> @@ -143,8 +144,6 @@
> */
> if (count <= 1)
> goto err;
> -
> - delta64 = end - start;
>
> /* cpu freq too fast: */
> if (delta64 > (1ULL<<32))
>
(added cc:)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
