On Fri, May 15, 2020 at 06:55:37PM +0800, Ramuthevar,Vadivel MuruganX wrote:
> From: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthe...@linux.intel.com>
>
> This patch adds the new IP of Nand Flash Controller(NFC) support
> on Intel's Lightning Mountain(LGM) SoC.
>
> DMA is used for burst data transfer operation, also DMA HW supports
> aligned 32bit memory address and aligned data access by default.
> DMA burst of 8 supported. Data register used to support the read/write
> operation from/to device.
>
> NAND controller driver implements ->exec_op() to replace legacy hooks,
> these specific call-back method to execute NAND operations.
...
> + ebu_host->dma_tx = dma_request_chan(dev, "tx");
> + if (IS_ERR(ebu_host->dma_tx)) {
> + ret = PTR_ERR(ebu_host->dma_tx);
> + dev_err(dev, "DMA tx channel request fail!.\n");
> + goto err_cleanup_dma;
> + }
> +
> + ebu_host->dma_rx = dma_request_chan(dev, "rx");
> + if (IS_ERR(ebu_host->dma_rx)) {
> + ret = PTR_ERR(ebu_host->dma_rx);
> + dev_err(dev, "DMA tx channel request fail!.\n");
rx ?
> + goto err_cleanup_dma;
> + }
...
> +static int ebu_nand_remove(struct platform_device *pdev)
> +{
> + struct ebu_nand_controller *ebu_host = platform_get_drvdata(pdev);
> +
> + if (ebu_host) {
I dunno why you need this check? Maybe I forgot your answer to my comment?
> + mtd_device_unregister(nand_to_mtd(&ebu_host->chip));
> + nand_cleanup(&ebu_host->chip);
> + ebu_nand_disable(&ebu_host->chip);
> + ebu_dma_cleanup(ebu_host);
> + clk_disable_unprepare(ebu_host->clk);
> + }
> +
> + return 0;
> +}
--
With Best Regards,
Andy Shevchenko
