In function pfuze100_regulator_probe(), variable "val" could be
initialized if regmap_read() fails. However, "val" is used to
decide the control flow later in the if statement, which is
potentially unsafe.
Signed-off-by: Yizhuo <yzhai...@ucr.edu>
---
drivers/regulator/pfuze100-regulator.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/drivers/regulator/pfuze100-regulator.c
b/drivers/regulator/pfuze100-regulator.c
index df5df1c495ad..689537927f6f 100644
--- a/drivers/regulator/pfuze100-regulator.c
+++ b/drivers/regulator/pfuze100-regulator.c
@@ -788,7 +788,13 @@ static int pfuze100_regulator_probe(struct i2c_client
*client,
/* SW2~SW4 high bit check and modify the voltage value table */
if (i >= sw_check_start && i <= sw_check_end) {
- regmap_read(pfuze_chip->regmap, desc->vsel_reg, &val);
+ ret = regmap_read(pfuze_chip->regmap,
+ desc->vsel_reg, &val);
+ if (ret) {
+ dev_err(&client->dev, "Fails to read from the
register.\n");
+ return ret;
+ }
+
if (val & sw_hi) {
if (pfuze_chip->chip_id == PFUZE3000 ||
pfuze_chip->chip_id == PFUZE3001) {
--
2.17.1
