A follow-up to my previous report about 2.2.18 bttv's new (worse) behavior:
Replacing 2.2.18's bttv.c with 2.2.17's fixes the problems.
- The green and purple fuzzy flash on a screen capture or channel change is
gone.
- The screen works after loading the module without TV->Composite->TV in
XawTV. (Especially important with automatic module loading.)
Hauppauge WinTV 401
00:14.0 Multimedia video controller: Brooktree Corporation Bt878 (rev 02)
Subsystem: Hauppage computer works Inc.: Unknown device 13eb
Flags: bus master, medium devsel, latency 32, IRQ 16
Memory at e4001000 (32-bit, prefetchable)
S3 Virge DX
00:11.0 VGA compatible controller: S3 Inc. ViRGE/DX or /GX (rev 01) (prog-if 00 [VGA])
Subsystem: S3 Inc. ViRGE/DX
Flags: bus master, medium devsel, latency 32, IRQ 19
Memory at e0000000 (32-bit, non-prefetchable)
Tyan Tomcat IV -- Pentium 233 MMX x2
00:00.0 Host bridge: Intel Corporation 430HX - 82439HX TXC [Triton II] (rev 03)
Flags: bus master, medium devsel, latency 32
I can try to narrow it down further if someone has ideas or I'll just try
whatever I can in the large chunks changed.
-George Greer
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
