From: "Ren� van Dorst" <[email protected]>
[ Upstream commit 8aace4f3eba2a3ceb431e18683ea0e1ecbade5cd ]
In phylink_parse_fixedlink() the pl->link_config.advertising bits are AND
with pl->supported, pl->supported is zeroed and only the speed/duplex
modes and MII bits are set.
So pl->link_config.advertising always loses the flow control/pause bits.
By setting Pause and Asym_Pause bits in pl->supported, the flow control
work again when devicetree "pause" is set in fixes-link node and the MAC
advertise that is supports pause.
Results with this patch.
Legend:
- DT = 'Pause' is set in the fixed-link in devicetree.
- validate() = ‘Yes’ means phylink_set(mask, Pause) is set in the
validate().
- flow = results reported my link is Up line.
+-----+------------+-------+
| DT | validate() | flow |
+-----+------------+-------+
| Yes | Yes | rx/tx |
| No | Yes | off |
| Yes | No | off |
+-----+------------+-------+
Fixes: 9525ae83959b ("phylink: add phylink infrastructure")
Signed-off-by: René van Dorst <[email protected]>
Acked-by: Russell King <[email protected]>
Signed-off-by: David S. Miller <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>
---
drivers/net/phy/phylink.c | 2 ++
1 file changed, 2 insertions(+)
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -226,6 +226,8 @@ static int phylink_parse_fixedlink(struc
__ETHTOOL_LINK_MODE_MASK_NBITS, true);
linkmode_zero(pl->supported);
phylink_set(pl->supported, MII);
+ phylink_set(pl->supported, Pause);
+ phylink_set(pl->supported, Asym_Pause);
if (s) {
__set_bit(s->bit, pl->supported);
} else {
