Hi,
Looks like dc2xx.c shouldn't use __devinit/__devexit
[patch attached]
or you should enable CONFIG_HOTPLUG under General Setup.
David?
The ov511 (usb) driver is the only other USB device driver
that uses __devinit/__devexit.
~Randy
josh wrote:
>
> Kernel Version: 2.4.0-test11 - 2.4.0-prerelease
> Platform: ix86 (PIII)
> Problem Hardware: Kodac DC280, firmware 1.01
>
> Ever since test10 or after, removing my dc280 from the usb
> bus causes khubd to crash. I have tried both UHCI drivers
> and they produce the same effect.
>
> dmesg, syslog, messages, and .config can be found at:
> http://mammoth.org/~skulcap/usb-problem
>
> I have looked throug the archives and havent found anything
> like this, so I'm sorry if it has been covered already.
>
> Thanks in advance!
--
_______________________________________________
|randy.dunlap_at_intel.com 503-677-5408|
|NOTE: Any views presented here are mine alone|
|& may not represent the views of my employer.|
-----------------------------------------------
--- linux/drivers/usb/dc2xx.c.org Sun Nov 12 20:40:42 2000
+++ linux/drivers/usb/dc2xx.c Wed Jan 3 11:15:11 2001
@@ -353,7 +353,7 @@
-static void * __devinit
+static void *
camera_probe (struct usb_device *dev, unsigned int ifnum, const struct usb_device_id
*camera_info)
{
int i;
@@ -451,7 +451,7 @@
return camera;
}
-static void __devexit camera_disconnect(struct usb_device *dev, void *ptr)
+static void camera_disconnect(struct usb_device *dev, void *ptr)
{
struct camera_state *camera = (struct camera_state *) ptr;
int subminor = camera->subminor;
