On Thu, Jul 04, 2019 at 10:40:44AM -0700, Paul E. McKenney wrote:
> On Thu, Jul 04, 2019 at 12:34:30AM -0400, Joel Fernandes (Google) wrote:
> > It is possible that the rcuperf kernel test runs concurrently with init
> > starting up. During this time, the system is running all grace periods
> > as expedited. However, rcuperf can also be run for normal GP tests.
> > Right now, it depends on a holdoff time before starting the test to
> > ensure grace periods start later. This works fine with the default
> > holdoff time however it is not robust in situations where init takes
> > greater than the holdoff time to finish running. Or, as in my case:
> >
> > I modified the rcuperf test locally to also run a thread that did
> > preempt disable/enable in a loop. This had the effect of slowing down
> > init. The end result was that the "batches:" counter in rcuperf was 0
> > causing a division by 0 error in the results. This counter was 0 because
> > only expedited GPs seem to happen, not normal ones which led to the
> > rcu_state.gp_seq counter remaining constant across grace periods which
> > unexpectedly happen to be expedited. The system was running expedited
> > RCU all the time because rcu_unexpedited_gp() would not have run yet
> > from init. In other words, the test would concurrently with init
> > booting in expedited GP mode.
> >
> > To fix this properly, let us check if system_state if SYSTEM_RUNNING
> > is set before starting the test. The system_state approximately aligns
Just minor typo..
To fix this properly, let us check if system_state if SYSTEM_RUNNING
is set before starting the test. ...
Should be
To fix this properly, let us check if system_state is set to
SYSTEM_RUNNING before starting the test. ...
Thanks,
Byungchul
> > with when rcu_unexpedited_gp() is called and works well in practice.
> >
> > I also tried late_initcall however it is still too early to be
> > meaningful for this case.
> >
> > Signed-off-by: Joel Fernandes (Google) <j...@joelfernandes.org>
>
> Good catch, queued, thank you!
>
> Thanx, Paul
>
> > ---
> > kernel/rcu/rcuperf.c | 8 ++++++++
> > 1 file changed, 8 insertions(+)
> >
> > diff --git a/kernel/rcu/rcuperf.c b/kernel/rcu/rcuperf.c
> > index 4513807cd4c4..5a879d073c1c 100644
> > --- a/kernel/rcu/rcuperf.c
> > +++ b/kernel/rcu/rcuperf.c
> > @@ -375,6 +375,14 @@ rcu_perf_writer(void *arg)
> > if (holdoff)
> > schedule_timeout_uninterruptible(holdoff * HZ);
> >
> > + /*
> > + * Wait until rcu_end_inkernel_boot() is called for normal GP tests
> > + * so that RCU is not always expedited for normal GP tests.
> > + * The system_state test is approximate, but works well in practice.
> > + */
> > + while (!gp_exp && system_state != SYSTEM_RUNNING)
> > + schedule_timeout_uninterruptible(1);
> > +
> > t = ktime_get_mono_fast_ns();
> > if (atomic_inc_return(&n_rcu_perf_writer_started) >= nrealwriters) {
> > t_rcu_perf_writer_started = t;
> > --
> > 2.22.0.410.gd8fdbe21b5-goog
> >
