Hello ! This is third version of patch set containing following patches for Cadence ethernet controller driver.
1. 0001-net-macb-add-phylink-support.patch Replace phylib API's with phylink API's. 2. 0002-net-macb-add-support-for-sgmii-MAC-PHY-interface.patch This patch add support for SGMII mode. 3. 0004-net-macb-add-support-for-c45-PHY.patch This patch is to support C45 PHY. 4. 0005-net-macb-add-support-for-high-speed-interface This patch add support for 10G USXGMII PCS in fixed mode. 5. 0006-net-macb-parameter-added-to-cadence-ethernet-controller-DT-binding New parameter added to Cadence ethernet controller DT binding for USXGMII interface. Changes in v2: 1. Dropped patch configuring TI PHY DP83867 from Cadence PCI wrapper driver. 2. Removed code registering emulated PHY for fixed mode. 3. Code reformatting as per Andrew's and Florian's suggestions. Changes in v3: Based on Russell's suggestions 1. Configure MAC in mac_config only for non in-band modes 2. Handle dynamic phy_mode changes in mac_config 3. Move MAC configurations to mac_config 4. Removed seemingly redundant check for phylink handle 5. Removed code from mac_an_restart and mac_link_state now just return -EOPNOTSUPP Regards, Parshuram Thombare Parshuram Thombare (5): net: macb: add phylink support net: macb: add support for sgmii MAC-PHY interface net: macb: add support for c45 PHY net: macb: add support for high speed interface net: macb: parameter added to cadence ethernet controller DT binding .../devicetree/bindings/net/macb.txt | 3 + drivers/net/ethernet/cadence/Kconfig | 2 +- drivers/net/ethernet/cadence/macb.h | 113 +++- drivers/net/ethernet/cadence/macb_main.c | 619 +++++++++++++----- 4 files changed, 554 insertions(+), 183 deletions(-) -- 2.17.1
