On Thu 13 Jun 07:22 PDT 2019, Jeffrey Hugo wrote:
> From: Jorge Ramirez-Ortiz <jorge.ramirez-or...@linaro.org>
>
> Signed-off-by: Jorge Ramirez-Ortiz <jorge.ramirez-or...@linaro.org>
> Signed-off-by: Jeffrey Hugo <jeffrey.l.h...@gmail.com>
> ---
> drivers/regulator/qcom_spmi-regulator.c | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/drivers/regulator/qcom_spmi-regulator.c
> b/drivers/regulator/qcom_spmi-regulator.c
> index 53a61fb65642..fd55438c25d6 100644
> --- a/drivers/regulator/qcom_spmi-regulator.c
> +++ b/drivers/regulator/qcom_spmi-regulator.c
> @@ -1744,6 +1744,7 @@ MODULE_DEVICE_TABLE(of, qcom_spmi_regulator_match);
> static int qcom_spmi_regulator_probe(struct platform_device *pdev)
> {
> const struct spmi_regulator_data *reg;
> + const struct spmi_voltage_range *range;
> const struct of_device_id *match;
> struct regulator_config config = { };
> struct regulator_dev *rdev;
> @@ -1833,6 +1834,12 @@ static int qcom_spmi_regulator_probe(struct
> platform_device *pdev)
> }
> }
>
> + if (vreg->logical_type == SPMI_REGULATOR_LOGICAL_TYPE_HFS430) {
This doesn't compile, because HFS430 isn't defined until patch 7.
But in patch 2 you replace this with a check to see if there's just a
single range, which is a better solution. So squash the last hunk of
patch 2 into this.
Regards,
Bjorn
> + /* since there is only one range */
> + range = spmi_regulator_find_range(vreg);
> + vreg->desc.uV_step = range->step_uV;
> + }
> +
> config.dev = dev;
> config.driver_data = vreg;
> config.regmap = regmap;
> --
> 2.17.1
>
