At 11:29 PM 12/25/00, you wrote:
>To verify that this is not an issue of the Promise controller, I started
>two instances of my test tool at the same time, one working on hde, the
>other on hdg (the two channels). Both yielded approximately 25 meg/sec,
>so it does not appear to be a hardware or driver issue. Is the RAID
>code really this slow? Any ideas what I can do?
Use two PDC controller cards. You have shown that you can read 50MB/s from
disks into memory, and so neither the IDE not PCI bus is overloaded.
However, the RAID code is contending for control of the IDE busses because
it is not optimized for the case that the disks cannot be controlled
independently.
>By the way: I noticed another thing: one of the Maxtor hard disks was
>broken. It caused the whole box to freeze solid (no numlock, no console
>switches, no sysrq). That to me severely limits the usefulness of IDE
Did you not read the RAID FAQ? look on the raidtools web site: it
specifically states:
a) you cannot hot swap IDE
b) if you put RAID disks on the same IDE bus (i.e. use master/slave) you
can expect abysmal performance. Only use the master for a given IDE bus
(i.e. the PDC supports 2, not 4, disks).
>RAID. While SCSI problems cause trouble, too, I have never seen one
>cause a complete freeze. How am I supposed to hot-swap the disks?
On IDE, you don't. IDE never supports hot-swap, RAID or no. If you want
that, use SCSI.
Regards,
Ruth
--
Ruth
Ivimey-Cook [EMAIL PROTECTED]
Technical
Author, ARM Ltd [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
