[PATCHv3 12/23] drivers: thermal: tsens: Don't print error message on -EPROBE_DEFER

[Amit Kucheria]

We print a calibration failure message on -EPROBE_DEFER from
nvmem/qfprom as follows:
[    3.003090] qcom-tsens 4a9000.thermal-sensor: version: 1.4
[    3.005376] qcom-tsens 4a9000.thermal-sensor: tsens calibration failed
[    3.113248] qcom-tsens 4a9000.thermal-sensor: version: 1.4

This confuses people when, in fact, calibration succeeds later when
nvmem/qfprom device is available. Don't print this message on a
-EPROBE_DEFER.

Signed-off-by: Amit Kucheria <amit.kuche...@linaro.org>
---
 drivers/thermal/qcom/tsens.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/thermal/qcom/tsens.c b/drivers/thermal/qcom/tsens.c
index b91a0b88d33c..057b33353ba3 100644
--- a/drivers/thermal/qcom/tsens.c
+++ b/drivers/thermal/qcom/tsens.c
@@ -159,7 +159,8 @@ static int tsens_probe(struct platform_device *pdev)
        if (priv->ops->calibrate) {
                ret = priv->ops->calibrate(priv);
                if (ret < 0) {
-                       dev_err(dev, "tsens calibration failed\n");
+                       if (ret != -EPROBE_DEFER)
+                               dev_err(dev, "tsens calibration failed\n");
                        return ret;
                }
        }
-- 
2.17.1